Nissan Navara Airbag Control Module Replacement Parts

Yes, all generations of the Nissan Navara sold in the UK were fitted with an airbag control module (also called the SRS control unit) as standard, managing the airbag and seatbelt pretensioner system throughout the cabin. This applies regardless of engine choice or drivetrain, so whether you have a petrol or diesel, 2WD or 4WD variant, the module will be present. It is typically located under the centre console or beneath the dashboard.

The Nissan Navara D40 generation ran from 2005 to 2015, so both a 2008 and a 2012 vehicle fall within the same generation — which is a positive starting point for compatibility. However, the airbag control module must be matched to the specific SRS system configuration of your vehicle, and compatibility can vary across production runs even within the same generation, so you should confirm the part against your registration with the breaker before buying. Because airbags are safety-critical components, professional fitting by a qualified technician is strongly recommended.

Yes, the Nissan Navara D40 (2005–2015) and the D23 (2016 onwards) are entirely different generations with different SRS systems, so the airbag control modules are not interchangeable between them. Always make sure the breaker is supplying a module from the correct generation by checking it against your vehicle's registration. Fitting an incorrect SRS module is a serious safety risk, so professional installation is essential.

Trim level can influence the SRS system configuration on the Navara — for example, higher trims such as the Tekna or Titanium may have additional side or curtain airbags compared with entry-level trims, and the control module must support the airbag channels fitted to your specific vehicle. Because of this, you should confirm the module's compatibility with your exact trim and SRS setup with the breaker, quoting your registration, rather than assuming any D40 or D23 module will simply plug in. As always, have the unit programmed and fitted by a qualified professional.

Airbag control modules are safety-critical parts, and fitting one incorrectly can result in airbags failing to deploy in a collision or deploying unexpectedly, both of which can cause serious injury. A used module will almost certainly require programming to your vehicle's VIN by a specialist with the appropriate diagnostic equipment, so DIY fitting is strongly discouraged. Always use a qualified automotive technician or auto-electrician for this work.

Yes — if the airbags in your Navara have deployed, the control module is treated as a single-use item and should be replaced rather than reused, as it records the crash event and may no longer function correctly. The same applies to seatbelt pretensioners, which are also single-use after activation. When sourcing a replacement from a breaker, always confirm that the module comes from a vehicle where the airbags did not deploy, and have the new unit professionally fitted and coded to your vehicle.