Cheap Hyundai ix35 Handbrake Cable
Compare prices on a used Hyundai ix35 handbrake cable from UK breakers. Free part request, no obligation.
Enter your registration or select your vehicle
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
Choosing the right used Hyundai ix35 handbrake cable
Used handbrake cables vary between vehicles - and whether you call it used, second hand or a replacement, matching the right one matters. These are the details breakers need to match the right part to your car - our request form asks them so you only hear from suppliers with the correct part:
- State whether it's left or right
Other used Hyundai ix35 parts
- Used Hyundai ix35 Wheel Trims
- Used Hyundai ix35 Wheel Bearing
- Used Hyundai ix35 Anti Roll Bar
- Used Hyundai ix35 Brake
- Used Hyundai ix35 Coil Spring
- Used Hyundai ix35 Fuel Tank
- Used Hyundai ix35 Window Switch
- Used Hyundai ix35 Timing Chain
- Used Hyundai ix35 Transfer Box
- Used Hyundai ix35 Oil Cooler
- Used Hyundai ix35 Brake Caliper
- Used Hyundai ix35 Aerial
Used handbrake cable for other Hyundai models
Fitment questions
Does the Hyundai ix35 have a handbrake cable?
Yes, the Hyundai ix35 is fitted with a conventional handbrake cable system operating the rear brakes, so a used cable is a genuine and commonly sourced part for this vehicle. This applies across both front-wheel-drive and four-wheel-drive variants of the ix35 sold in the UK.
Will a handbrake cable from a 2010-2013 ix35 fit a 2013-2015 facelift model?
The ix35 ran from 2010 to 2015 in the UK, with a facelift arriving around 2013 that brought exterior and interior updates but no fundamental change to the rear brake and handbrake layout. In practice the cable is often compatible across the full production run, but because the facelift boundary is a known cut-off point you should confirm the exact part reference with the breaker against your registration before buying.
Does engine size affect which handbrake cable I need for my ix35?
For the ix35, the handbrake cable is tied to the rear brake assembly rather than the engine, so in most cases the 1.6 petrol, 2.0 petrol, 1.7 diesel, and 2.0 diesel variants share the same rear setup and the same cable. However, the 4WD versions may differ from front-wheel-drive versions due to differences in the rear axle arrangement, so always confirm FWD or 4WD with the breaker when ordering.
Does the ix35 trim level - S, SE, Premium, or Style - affect which handbrake cable fits?
Trim level does not affect handbrake cable fitment on the ix35 - whether your car is an entry-level S or a higher-spec Premium or Style, the rear brake and cable setup is the same. You may find cosmetic differences around the interior handbrake lever between trims, but the cable itself is interchangeable across the range.
Is there a NS or OS difference with ix35 handbrake cables - do I need to specify a side?
Handbrake cables on the ix35 typically run from a central equaliser to each rear wheel, meaning there is usually a separate NS (nearside, left) and OS (offside, right) rear cable as well as a primary cable from the lever. When contacting a breaker, confirm which section of the cable has failed - lever-to-equaliser or equaliser-to-wheel - and specify the side if you need a rear branch cable.
Can I use an ix35 handbrake cable from any year of the model, or do early and late cars differ?
The ix35 used broadly consistent underpinnings throughout its 2010 to 2015 UK run, and the handbrake cable design did not undergo a major revision in that period. That said, minor production changes can occur within a model run, so treat any cross-year fitment as needing verification - give the breaker your full registration so they can check the part number matches before you commit.