Used Nissan 350Z Alloy Wheels

The Nissan 350Z was produced from 2003 to 2009 as a single generation, sharing the same 5x114.3 PCD and 66.1mm centre bore throughout the run, so wheels from any year of 350Z are generally compatible with any other year. You should also confirm the offset matches your car, as the standard offset is typically ET30–ET40 depending on the specific wheel. Always confirm the exact specs with the breaker against your registration before purchasing.

The 350Z received a facelift in 2005, but this was a styling update and did not change the wheel bolt pattern, centre bore, or offset specification, so pre-facelift (2003–2005) and post-facelift (2005–2009) alloys are generally interchangeable. The wheel design changed cosmetically between the two periods, so the look may differ from the factory fit on your car. Confirm the exact offset of the specific set with the breaker against your registration to be sure.

The 370Z uses the same 5x114.3 PCD and a similar centre bore, so there is potential for interchange, but the 370Z uses different offsets and wider wheel sizes compared to the 350Z. Whether a specific set of 350Z wheels will fit a 370Z correctly — particularly with different tyre sizes in play — is something you should confirm with the breaker against your registration rather than assume.

Trim level does not affect the fundamental fitment of alloy wheels on the 350Z; the PCD, centre bore, and offset are the same across trims including GT and Touring variants. What may differ is the original wheel size and design fitted as standard to each trim, so a set sourced from a different trim may look different to your original wheels. As long as PCD, offset, and centre bore match, the trim the wheels came from is not a barrier to fitment.

Many Nissan models from this era share the 5x114.3 PCD, which means alloys from models such as the Nissan Skyline or some Infiniti G-series could potentially fit in terms of bolt pattern. However, centre bore and offset can vary between models, and whether a specific set from another model fits correctly — especially with different tyre sizes — should be confirmed with the breaker against your registration.

Some 350Z models were fitted with TPMS (tyre pressure monitoring systems), so if your car has this system, the sensors in a used set of wheels may not be compatible with your car's receiver. This is something you should confirm directly with the breaker against your registration, as sensor compatibility is not straightforward to verify without knowing the exact part numbers involved.