Findapart

Used Škoda Yeti Track Rod

Compare prices on a used Škoda Yeti track rod from UK breakers. Free part request, no obligation.

Enter your registration or select your vehicle

Find the right part faster and get quotes direct from UK breakers - free, and no obligation.

GB

A buyer's guide to used Škoda Yeti track rod

No two track rods are quite the same across different vehicles, so getting the specifics right matters when you buy used, second hand or a replacement. Answer a few quick questions below and breakers will only quote if they have the exact matching part in stock:

Other used Škoda Yeti parts

Used track rod for other Škoda models

Fitment questions

Does the Škoda Yeti have a track rod, and which end does it fit?

Yes, the Škoda Yeti has track rods (also called track rod ends) on both the nearside (NS, driver's left) and offside (OS, driver's right) of the front steering assembly — all variants of the Yeti, whether front-wheel drive or four-wheel drive, use a conventional rack-and-pinion setup with track rods. When ordering from a breaker, always specify which side you need, as NS and OS are not interchangeable. Confirm the side against your own vehicle before requesting a quote.

Will a track rod from an earlier Škoda Yeti (2009–2013) fit a facelifted Yeti (2013–2017)?

The Škoda Yeti ran from 2009 to 2017, with a facelift arriving in 2013 that brought styling updates but used the same underlying platform throughout the model's life. Because the steering geometry was carried over, track rods from pre-facelift and post-facelift Yetis are often compatible, but this is not guaranteed — confirm the part number against your registration with the breaker before purchasing, as subtle specification changes can affect fitment across that 2013 boundary.

Does engine size affect which track rod I need for my Škoda Yeti?

For the Yeti, the track rod fitment is primarily determined by the generation and steering rack specification rather than engine size alone, so a 1.2 TSI and a 2.0 TDI of the same generation will typically use the same track rod. That said, four-wheel-drive variants may have slightly different front suspension loading considerations, so always quote your exact engine and drivetrain (2WD or 4WD) to the breaker when requesting a part.

Does trim level affect which track rod fits my Škoda Yeti — for example, does an S or SE spec car need a different part?

Trim level does not affect track rod fitment on the Škoda Yeti — the steering components are the same regardless of whether the car is S, SE, Elegance, or Outdoor specification. You may find cosmetic differences between stripped-out donor vehicles from breakers (such as missing interior or body trim), but the track rod itself is unaffected by trim. Focus on generation, drivetrain (2WD or 4WD), and side (NS or OS) when sourcing the part.

Can I use a track rod from a 2012 Yeti on a 2015 Yeti?

A 2012 Yeti is pre-facelift and a 2015 Yeti is post-facelift (the facelift arrived in 2013), so these sit either side of a known model boundary. The platform and steering rack architecture remained consistent across the full 2009–2017 production run, which suggests cross-generation fitment is plausible, but you should confirm the part numbers match against both registrations with the breaker rather than assume compatibility across that 2013 boundary.

Is a Škoda Yeti track rod the same as one from a VW Tiguan or SEAT Altea?

The Škoda Yeti shares its PQ35 platform with several VAG group vehicles including the VW Tiguan and SEAT Altea, and track rod components can sometimes be shared across these models. However, suspension geometry and rack specifications can differ between marques and model years even on shared platforms, so cross-platform fitment should always be verified by comparing part numbers with the breaker against your specific registration — never assume a VAG group part is a direct swap without that check.