Need a used Škoda Kamiq oxygen sensor? Request a free quote from UK vehicle dismantlers and compare offers direct.
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
Fitment on a used oxygen sensor varies by vehicle, so a bit of detail goes a long way. Our request form covers what breakers need to know, so every quote you get back is for the correct part:
Yes, petrol-engined Kamiqs are fitted with lambda (oxygen) sensors as part of their exhaust and engine management system, typically with sensors both before and after the catalytic converter. Diesel variants use a different emissions strategy and do not use traditional wideband lambda sensors in the same way, relying instead on NOx and particulate sensors, so if you have a diesel Kamiq you are likely looking for something different. Check your fuel type before searching, as the parts are entirely different.
The Kamiq launched in the UK in 2019 and received a facelift around 2024, and while it has been a single-generation model across that span, engine code is the critical fitment factor rather than build year alone. Sensors are matched to specific engine families — for example the 1.0 TSI and 1.5 TSI units have different sensor specifications — so confirm the engine code from your V5C before ordering. A sensor from the wrong engine code is unlikely to give correct readings even if it physically fits.
No, trim level makes no difference to oxygen sensor fitment on the Kamiq — SE, SE L, Sportline, and Monte Carlo trims all use the same sensor for a given engine code and fuel type. What matters is engine code and whether the vehicle is Euro 6 compliant, which all UK Kamiqs are. You may find cosmetic differences around the exhaust area between trims, but the sensor itself is determined by the engine, not the badge.
The Kamiq facelift arrived around 2024, and while carry-over engines may use the same sensor part number across that boundary, you should not assume this without checking. Name the generation boundary to your breaker and ask them to cross-reference your specific engine code, as even a visually identical sensor from the wrong engine calibration can cause incorrect fuelling or a failed emissions test. Confirming against your registration is the safest approach here.
Yes, the position matters significantly — the upstream (pre-cat) sensor measures exhaust gases directly from the engine and is usually a wideband lambda sensor, while the downstream (post-cat) sensor monitors catalytic converter efficiency and may be a different type or specification. Fitting the wrong one in the wrong position can cause fault codes, poor economy, and a failed MOT emissions test. Tell the breaker which position you need and confirm it against your engine code.
Because Škoda, VW, and SEAT share engine families across the VAG group, a sensor from a matching engine code in another model can sometimes be compatible, and breakers will often supply them this way. However, exhaust routing and sensor connector position can differ between body styles, so a direct swap is not guaranteed even with an identical engine code. Ask your breaker to confirm the part number against your Kamiq's registration rather than relying on engine code alone.