Findapart

Škoda Kamiq Parking Sensor Replacement Parts

Compare prices on a used Škoda Kamiq parking sensor from UK breakers. Free part request, no obligation.

Enter your registration or select your vehicle

Find the right part faster and get quotes direct from UK breakers - free, and no obligation.

GB

What to check when buying a used Škoda Kamiq parking sensor

A used parking sensor that fits one vehicle won't always fit another - even within the same model range. These questions help breakers match stock to your exact vehicle before they quote:

Other used Škoda Kamiq parts

Used parking sensor for other Škoda models

Fitment questions

Will a parking sensor from an older Škoda Kamiq fit my newer one?

The Škoda Kamiq was launched in the UK in 2019 and received a facelift in 2021, so there is a pre-facelift generation (2019–2021) and a post-facelift generation (2021 onwards). Parking sensors from the same generation should be a straightforward match, but if you are crossing that 2021 facelift boundary, confirm with the breaker against your registration as connector or bumper mounting positions may have changed.

Does the Škoda Kamiq actually come with parking sensors?

Yes, parking sensors were offered on the Kamiq, though fitment depends on trim and optional packs rather than being standard across the entire range. Front and rear sensors were available on higher trims and as part of optional packages, so check what your specific car was built with before ordering — the breaker can verify this against your registration.

Does it matter which trim my Kamiq is — will sensors from an SE fit an SE L or Monte Carlo?

Trim level does not affect whether the sensor unit itself is compatible, as the sensor and wiring are not trim-specific in the way that mechanical parts are. However, bumper colour and finish will differ between trims, so if you are replacing a sensor on a painted bumper, bear in mind any cosmetic differences to expect from a donor car on a different trim. Confirm the exact part and connector type with the breaker against your registration to be sure.

Can I use Škoda Kamiq parking sensors from a different Škoda or Volkswagen Group car?

Parking sensors across the Volkswagen Group (Škoda, VW, Seat, Audi) often share the same supplier and connector standards, so cross-model compatibility is possible in some cases. That said, sensor diameter, frequency, and wiring plugs can vary by model year and specification, so this is not something to assume — check with the breaker and quote your registration so they can match the correct part.

Does a 2019 Kamiq parking sensor fit a 2022 Kamiq?

These two cars sit either side of the 2021 facelift, which means there may be differences in bumper design and sensor mounting that affect fitment. Name the boundary confidently: pre-facelift runs 2019–2021 and post-facelift from 2021 onwards, and crossing that line introduces genuine uncertainty. Route this to the breaker and give them your full registration so they can confirm whether the donor part is compatible with your specific build.

Are front and rear parking sensors interchangeable on the Kamiq?

Front and rear parking sensors on the Kamiq may use the same sensor unit physically, but they are part of separate loom and control module setups, so you should not assume they are a straight swap without checking. Always tell the breaker whether you need a front or rear sensor and confirm against your registration, as some cars were fitted with rear sensors only while others had both front and rear.