Peugeot 3008 Rear Bumper Replacement Parts

The 3008 runs across two distinct generations: the first generation covered 2009 to 2016, and the second generation ran from 2016 onwards, with a facelift arriving around 2020. Rear bumpers are not interchangeable between these two generations as the body panels are completely different designs. Within each generation, year-to-year fitment is generally consistent, but confirm the exact year of the donor vehicle with the breaker against your registration to be sure.

Both the 2013 and 2015 3008 sit within the first generation (2009–2016), so the rear bumper design is the same family and fitment is generally expected to be compatible. However, Peugeot did make pressing or detail changes during this generation's production run, so confirm with the breaker using both registrations before purchasing. Never assume a used part will fit without that check.

The second-generation 3008 received a facelift around 2020, and while the platform is shared, the rear bumper styling was updated at that point. A bumper from a pre-facelift second-generation car (2016–2020) may not align correctly with a post-facelift model due to changes in the lower panel shape and light apertures. Route this question to the breaker and give them both registrations so they can confirm whether the pressing matches your car.

Trim level does not affect rear bumper fitment on the 3008 — Active, Allure, and GT Line all use the same bumper shell within a given generation. What may differ cosmetically are items like parking sensor hole positions, diffuser inserts, or trim finishes, so a bumper from a lower trim may need your existing sensors or trim pieces transferred across. The breaker can supply the shell; just be aware of any cosmetic finishing differences you may need to address.

No — the first generation (2009–2016) and second generation (2016 onwards) are entirely different platforms with completely redesigned bodywork, so the rear bumpers are not interchangeable. You must match the bumper to the correct generation, and the easiest way to do this is to provide your full registration to the breaker so they can pull the exact specification. Do not attempt to fit a bumper across this generational boundary.

Engine choice has no bearing on rear bumper fitment for the 3008 — whether your car is a petrol, diesel, or plug-in hybrid, the bumper is determined by the generation and body style, not what is under the bonnet. Focus on getting the correct generation (first gen 2009–2016 or second gen 2016 onwards) and confirming the model year with the breaker. This will save time and avoid ordering a part that does not fit.