Nissan Micra Brake Discs Replacement Parts

The Micra uses brake discs on the front axle across all generations, so front discs are a genuine used part to search for. Rear brake arrangement varied by generation and engine size — earlier and smaller-engined Micras typically used rear drums, while some later or larger-engined variants gained rear discs, so check which setup your car has before ordering. A breaker can confirm against your registration what rear arrangement your specific car left the factory with.

The K11 (1993–2002) and K12 (2003–2010) are entirely different generations with different subframes, hubs, and brake dimensions, so the discs are not interchangeable. Always source discs matched to your generation — confirm the generation with your registration plate when contacting a breaker.

Yes, engine size can influence brake disc diameter, particularly on the K12 and K13 generations where the 1.6-litre engine was sometimes paired with larger front discs than the smaller 1.0 and 1.2 units. When contacting a breaker, give them your exact engine size alongside the generation so they can match the correct disc dimensions for your car.

The K12 ran from 2003 to 2010 with a facelift in 2007 that was largely cosmetic, and in most cases front brake disc dimensions remained consistent across the K12 generation. However, whether a specific disc crosses the pre- and post-facelift boundary without issue is worth confirming with the breaker against your registration, as mid-generation running gear updates can sometimes affect fitment.

Trim level alone — Visia, Acenta, Tekna or otherwise — does not determine brake disc fitment on the K13 Micra; what matters is engine size and whether your car has rear discs or rear drums. A disc pulled from an Acenta and one from a Tekna of the same engine size and year should be dimensionally the same, though cosmetic differences in surface finish or venting are possible on used parts. Confirm the engine size and axle with the breaker rather than focusing on trim name.

The E12 (2017 onwards) is a completely new generation on a new platform, sharing no running gear with the K13 (2010–2017), so the brake discs are not compatible between these generations. Make sure you specify the correct generation to your breaker, ideally quoting your registration so they can pull the exact spec your car requires.