Need a used Škoda Yeti handbrake cable? Request a free quote from UK vehicle dismantlers and compare offers direct.
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
Used handbrake cables vary between vehicles - and whether you call it used, second hand or a replacement, matching the right one matters. These are the details breakers need to match the right part to your car - our request form asks them so you only hear from suppliers with the correct part:
The Škoda Yeti (2009–2017) uses a traditional mechanical handbrake lever with physical cables rather than an electronic parking brake system, so yes, handbrake cables do exist on this model and are a genuine serviceable part. There are typically two rear cables (one to each rear wheel) plus a front equaliser section, so make sure you identify which section has failed before ordering. All mainstream Yeti variants across the production run used this mechanical setup.
The Yeti was facelifted in 2013–2014, and while the basic handbrake layout remained mechanical throughout, the rear suspension and brake assembly saw some revisions across this boundary, which may affect cable routing and end fittings. We'd strongly recommend confirming the exact cable against your registration with the breaker before buying, rather than assuming pre-facelift and post-facelift cables are interchangeable. Supply your full reg so the breaker can check part numbers directly.
Engine size can influence rear brake specification on the Yeti — larger or more powerful engines sometimes paired with uprated rear brakes, which can mean different cable lengths or end fittings. It's worth telling the breaker your exact engine code and displacement (e.g. 1.2 TSI, 1.4 TSI, 2.0 TDI) alongside your registration so they can match accurately. Don't assume a cable from a 1.2 will be a straight swap onto a 2.0 TDI without checking.
The Yeti was available in both front-wheel-drive and 4WD (4x4) variants, and the rear axle setup differs between the two, so there is a real possibility that cable routing, length, or end fittings differ between drivetrains. Always tell the breaker whether your Yeti is 4WD or FWD — ideally supply your registration so they can confirm the correct cable. Fitting the wrong cable could leave the handbrake ineffective, so this is not a detail to overlook.
Trim level does not affect handbrake cable fitment on the Yeti — the cables are determined by drivetrain, engine, and build date rather than whether you have an S, SE, Elegance, or L&K model. You may find minor cosmetic differences on parts pulled from donor cars at different spec levels, but the cables themselves are mechanically identical across trims where all other specs match. Focus on matching engine size, drivetrain, and model year rather than trim name.
You can buy individual nearside (NS) or offside (OS) rear cables separately, and many breakers will sell them individually from a donor car. That said, if one cable has stretched or corroded significantly, the other is often in a similar condition, and fitting a used cable to match an aged one can make balancing the handbrake tricky. Let the breaker know which side you need and ask about the condition of both cables on their donor vehicle so you can make an informed decision.