Compare prices on a used Škoda Superb handbrake cable from UK breakers. Free part request, no obligation.
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
Used handbrake cables vary between vehicles - and whether you call it used, second hand or a replacement, matching the right one matters. These are the details breakers need to match the right part to your car - our request form asks them so you only hear from suppliers with the correct part:
It depends on the generation. The Mk1 Superb (2001–2008) and Mk2 Superb (2008–2015) use a conventional mechanical handbrake with a cable, so a physical handbrake cable does exist on those cars. The Mk3 Superb (2015 onwards) uses an electronic parking brake (EPB) actuated by a button, meaning there is no traditional handbrake cable to replace on that generation — if your Mk3 has a parking brake fault, you are looking at the EPB motor or module rather than a cable.
Both years fall within the Mk2 generation (2008–2015), so you are within the same basic platform, which is a good starting point. However, the Mk2 received a facelift in 2013, and it is worth confirming with the breaker that the cable from the specific donor vehicle matches your registration, as minor running-gear revisions can occur across a facelift even when the generation name stays the same. Never assume a direct swap without checking part numbers.
Trim level does not affect handbrake cable fitment on the Superb — the S, SE, and Elegance trims share the same braking and cable setup within a given generation. What can affect fitment is engine size, since larger-engined variants sometimes carry uprated rear brakes, so do mention your engine size when asking a breaker for a quote. The cable you receive from a different trim car may look slightly different cosmetically but that is not a fitment concern.
Possibly yes — larger engines, particularly the higher-output 2.0 TDI and V6 petrol variants, can be paired with larger rear brake assemblies, and the cable geometry or length may differ accordingly. When contacting a breaker, always give your full engine size and ideally your VIN or registration so they can verify against the donor vehicle. Do not assume a cable from a 1.6 TDI car will be a guaranteed fit on a 3.6 V6 model without checking.
No — the Mk1 and Mk2 Superb are based on different platforms and the rear suspension and brake layouts differ between generations, so the cables are not interchangeable. Always source a cable from the same generation as your car, and confirm the specific engine variant with the breaker to make sure the donor car's setup matches yours. Cross-generation parts in the braking system should never be assumed compatible.
Not in the traditional sense — the Mk3 Superb (2015 onwards) uses an electronic parking brake with no manual cable, so there is no handbrake cable to replace. The fault is most likely with the EPB actuator motor, wiring, or control module, and a breaker supplying the Mk3 can quote you for those components instead. A diagnostic scan is the sensible first step to identify exactly which part has failed before ordering anything.