Get quotes for a used or replacement Škoda Rapid suspension leg. Genuine second hand parts from UK vehicle dismantlers - free request, breakers with stock reply direct.
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
Fitment on a used suspension leg varies by vehicle, so a bit of detail goes a long way. Our request form covers what breakers need to know, so every quote you get back is for the correct part:
Yes, the Škoda Rapid is a front-wheel-drive car and uses MacPherson strut suspension legs at the front axle, so this is a genuine part on the car. At the rear, the Rapid uses a torsion beam rather than individual suspension legs, so if you need a rear suspension component, a suspension leg is not what you are looking for. Make sure you have confirmed whether you need a front NS (nearside/left) or OS (offside/right) unit before contacting a breaker.
The Škoda Rapid was produced from 2012 onwards, and while the car carried a facelift during its production run, the fundamental front suspension architecture remained MacPherson strut throughout. A 2013 unit and a 2016 unit may share the same basic fitment, but whether the strut assembly crosses that facelift boundary without issue is something you should confirm with the breaker against your exact registration, as spring and damper rate variants can differ mid-generation. Always quote your reg to the breaker so they can check against the original spec.
Engine size can influence the suspension specification on many cars because heavier or more powerful engines sometimes require uprated components, and this can apply to the Rapid where different engine options were offered. For the most part the front strut mounting points are consistent across the Rapid range, but whether the specific damper rating or spring rate matches your car's engine variant is not something that can be guaranteed without checking. Confirm the engine size from your V5C or registration plate with the breaker to make sure the unit they have matches your original specification.
Trim level does not affect suspension leg fitment on the Škoda Rapid - the front MacPherson strut assembly is determined by the generation and engine, not by whether the car is an S, SE, or Elegance. You may find cosmetic differences in the condition or finish of secondhand parts from different trim levels, but these do not affect whether the part will fit. Focus on matching the generation, engine size, and side (NS or OS) rather than the trim name.
In UK breakers' yards, the front left is referred to as the nearside (NS) front, as nearside means the kerb side of the car. When contacting a dismantler through Findapart, quote your registration number, confirm it is the front NS suspension leg you need, and mention your engine size, as these details will help the breaker pull the correct unit from their stock. Getting the side right is essential as NS and OS struts are handed and will not swap over.
The Rapid's front suspension leg is likely to be shared across much of the production run given the consistent platform, but you should not assume any year will cross over without checking, particularly around any facelift or specification change years. Spring and damper rate variants, and any differences introduced for sport suspension or specific engine pairings, are topics where the breaker needs to verify compatibility against your registration rather than rely on a year-range assumption alone. Always provide your full registration to the breaker so they can match the correct spec rather than just the model name and year.