Compare prices on a used Škoda Kodiaq lambda sensor from UK breakers. Free part request, no obligation.
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
No two lambda sensors are quite the same across different vehicles, so getting the specifics right matters when you buy used, second hand or a replacement. Answer a few quick questions below and breakers will only quote if they have the exact matching part in stock:
Yes, but only on petrol-engined Kodiaqs — the lambda (oxygen) sensor is part of the exhaust management system that helps the ECU control fuelling on petrol engines. Diesel Kodiaqs use different exhaust aftertreatment (NOx sensors, DPF, SCR) rather than a traditional lambda sensor, so if your Kodiaq is diesel you will not find a lambda sensor on it. Check your V5 or the plate under the bonnet to confirm petrol or diesel before searching.
The Kodiaq launched in 2017 and received a facelift in 2021, so both a 2017 and a 2020 car sit within the same pre-facelift generation — however fitment of a lambda sensor depends on matching the engine code exactly, not just the model year. Petrol Kodiaq variants include different 1.4 TSI and 1.5 TSI and 2.0 TSI units, each of which can have sensors in different positions or with different connector types. Confirm the engine code (found on the V5 or stamped on the block) with the breaker before buying.
No — trim level makes no difference to lambda sensor fitment on the Kodiaq; what matters is the engine code and whether the car is Euro 6 compliant, not whether it is an S, SE, SE L, Edition, Sportline or vRS. A used sensor pulled from a Kodiaq of any trim should suit another of the same engine code and emissions standard. Do bear in mind that a used sensor may show corrosion or wiring differences depending on age and mileage, so inspect the connector and cable length when it arrives.
The facelifted Kodiaq arrived for the 2021 model year, and while many engine codes carried over, revised engine management calibrations mean a sensor from before the facelift boundary may not perform correctly even if it physically plugs in. This is strong confirm-with-the-breaker territory — give them both registration numbers and ask them to verify the engine code and sensor part number matches before committing. Never assume physical similarity means functional compatibility across a generation boundary.
Petrol Kodiaqs typically have at least two lambda sensors — one upstream (pre-cat, sometimes called the front or bank sensor) and one downstream (post-cat, used to monitor catalytic converter efficiency) — and the two are not interchangeable with each other. The upstream sensor usually has a different thread pitch, cable length or connector from the downstream one, so you need to tell the breaker which position you require as well as the engine code. If you are unsure which has failed, a diagnostic scan will show which sensor code is flagged before you search for a replacement.
Engine size alone is not a reliable guide; a 1.5 TSI and a 2.0 TSI are different engine families and are likely to use different sensors, connectors and calibrations even though both are petrol units. Always match on engine code rather than displacement, and confirm the sensor position (upstream or downstream) is the same, as mixing these up is a common and costly mistake. Ask the breaker to cross-reference both engine codes and confirm the OEM part number before purchase — this is especially important for post-2021 Euro 6d engines where emissions compliance affects MOT.