Compare prices on a used Škoda Fabia lambda sensor from UK breakers. Free part request, no obligation.
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
Fitment on a used lambda sensor varies by vehicle, so a bit of detail goes a long way. Our request form covers what breakers need to know, so every quote you get back is for the correct part:
The Fabia ran as the Mk2 generation from 2007 to 2014, with a facelift around 2010, so a 2008 and a 2012 are both Mk2 but from either side of that facelift boundary — engine code is the key thing to match, not the year alone. Lambda sensors follow the engine and its emissions calibration, so if both cars share the same engine code (for example 1.2 HTP or 1.4 TDI) there is a reasonable chance of compatibility, but crossing the pre- and post-facelift boundary means the exhaust setup and ECU mapping may differ. Confirm the engine code on both vehicles and check with the breaker before buying.
The Mk1 Fabia ran from 1999 to 2007 and the Mk2 from 2007 to 2014, and these are entirely different generations with different engine families and exhaust systems, so cross-generation fitment is very unlikely. Lambda sensors are matched to the specific engine code and its emissions calibration, and mixing generations is a strong route to a misfire, fault codes, or an MOT failure. Stick within the correct generation and match on engine code, and confirm with the breaker against your registration.
Lambda sensors exist on petrol-engined Fabias across all three generations, where they are used by the ECU to manage the air-fuel mixture and keep the catalytic converter working correctly. Diesel Fabias do not use a traditional lambda sensor in the same way, because diesel engines run lean by design and manage emissions differently — if you have a diesel Fabia and are chasing an emissions or EGR-related fault, a lambda sensor is not the part you need. Check your engine code (petrol codes include things like AUA, BBZ, CHFA, and CGPA depending on generation) and confirm you have a petrol variant before ordering.
Trim level makes no difference to lambda sensor fitment on the Fabia — Active, Ambition, Elegance, Monte Carlo, and vRS trims all use sensors determined by the engine code and emissions specification, not by the badge on the back. The only thing worth noting is that the vRS uses sportier engine variants (such as the 1.4 TSI in the Mk2 era) which will have their own specific sensor, but that is down to the engine code, not the vRS trim itself. Match on engine code and fuel type and ignore the trim name entirely.
The Mk3 Fabia launched in 2014, so a 2015 car is a Mk3, built on the MQB-A0 platform with a new engine range including 1.0 MPI and 1.2 TSI petrol units — these are different engines to the Mk2 and require their own lambda sensors. This is an important generation boundary because a Mk2 sensor will not be the right part for a Mk3 engine, even if the connector looks similar. Always confirm the engine code with the breaker against your exact registration to make sure you get the right sensor for your generation.
Different engine sizes typically run different engine codes, different fuelling maps, and sometimes different exhaust configurations, so swapping a lambda sensor between a 1.2 and a 1.4 petrol is not straightforward even within the same generation. The sensor type, thread size, connector, and calibration all need to align with your specific engine code, and fitting the wrong one can cause running problems or trip the emissions warning light. Give the breaker your engine code (found on your V5C or visible on the engine block) rather than just the engine size, and let them match from there.