Nissan Cabstar Wheel Trims Replacement Parts

The Nissan Cabstar is a light commercial truck (LCV) that is almost universally sold with steel wheels designed to be used without wheel trims — the vast majority of Cabstar variants left the factory with bare steel wheels and no trim covers fitted. Wheel trims are not a standard or common fitment on any generation of the Cabstar, so there is unlikely to be a genuine used Cabstar wheel trim available from a breaker. If you need to cover the steel wheels on your Cabstar, you would be looking at aftermarket universal-fit van wheel trims sized to match your wheel diameter (typically 15 or 16 inch depending on variant), not a vehicle-specific Cabstar part.

Because Nissan did not fit wheel trims to the Cabstar as standard equipment, any wheel trims listed for this vehicle will almost certainly be universal aftermarket products sized to fit the steel wheel diameter, rather than genuine Nissan-specific trim covers. When buying, the key measurement you need is the wheel diameter in inches and the centre-bore size so the trim clips or retaining ring seats correctly — check the tyre sidewall and your vehicle's handbook for these figures. A breaker is unlikely to have Cabstar-specific wheel trims to sell you, so a motor accessory retailer selling sized universal trims is the more practical route.

Because wheel trims were not a standard factory fitment on any Cabstar generation — including the earlier E-series and the F24 generation introduced around 2006 — there is no genuine generation-to-generation interchange question to answer here in the usual sense. The relevant dimension is simply the steel wheel rim diameter, which can vary across generations and payload variants, so you would need to confirm your wheel size before buying any universal trim. A breaker who has dismantled a Cabstar is unlikely to have wheel trims to offer at all, and fitting guidance from one generation to another is not applicable for a part that was not originally fitted.

Payload and GVW rating affect the wheel and tyre specification on the Cabstar — higher GVW variants may run larger or dual-rear-wheel configurations — and this would directly affect what size universal wheel trim would be needed if you want to fit covers. Check the plate in the door shut or cab for your vehicle's exact GVW and cross-reference the steel wheel rim size, as these can differ between lighter and heavier-rated variants. Because wheel trims are not a factory Nissan fitment, there are no breaker-sourced Cabstar-specific trims to match to your payload rating, so sizing a universal aftermarket trim correctly is the practical approach.

It is possible that a universal steel-wheel trim sized in the same diameter as your Cabstar's wheels might physically clip onto the rim regardless of which vehicle range it was originally marketed for, but this depends entirely on rim diameter, the clip or retaining-ring design, and centre-bore clearance rather than on model compatibility. The Cabstar, Navara, and Interstar are very different vehicles with different wheel specifications, so a trim from one is not reliably interchangeable with another without checking the actual wheel dimensions match. If you are set on fitting wheel trims to a Cabstar, the safest route is to measure your rim diameter and centre bore and buy a universal trim to those figures, rather than trying to cross-reference from another model.