Cheap Alfa Romeo MiTo Bonnet Strut
Compare prices on a used Alfa Romeo MiTo bonnet strut from UK breakers. Free part request, no obligation.
Enter your registration or select your vehicle
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
Other used Alfa Romeo MiTo parts
- Used Alfa Romeo MiTo Bumper
- Used Alfa Romeo MiTo Side Skirt
- Used Alfa Romeo MiTo Slam Panel
- Used Alfa Romeo MiTo Spoiler
- Used Alfa Romeo MiTo Radiator
- Used Alfa Romeo MiTo Engine Mount
- Used Alfa Romeo MiTo Parcel Shelf
- Used Alfa Romeo MiTo Window Regulator
- Used Alfa Romeo MiTo Window Motor
- Used Alfa Romeo MiTo Water Pump
- Used Alfa Romeo MiTo Steering Wheel Airbag
- Used Alfa Romeo MiTo Aerial
Used bonnet strut for other Alfa Romeo models
Fitment questions
Does the Alfa Romeo MiTo actually have a bonnet strut, or does it use a bonnet stay rod?
The MiTo uses a traditional metal stay rod to prop the bonnet open rather than a gas-strut system, so there is no bonnet strut listed as a separate purchasable part for this model. If your bonnet won't stay up, the part you're most likely looking for is the bonnet stay rod and its retaining clip or rubber grommet. Search for 'Alfa Romeo MiTo bonnet stay rod' or ask your breaker for the prop rod when requesting a quote.
What should I actually be searching for if I need to keep my MiTo bonnet propped up?
The correct part is the bonnet stay rod — a simple metal or plastic-tipped rod that clips into a holder on the bonnet and slots into a hole in the engine bay to hold the bonnet open. Breakers will know this as the bonnet stay or bonnet prop rod, and it is a common request for the MiTo. Check that the retaining clip that holds the rod to the bonnet underside is intact too, as these often go missing on dismantled cars.
Will a bonnet stay rod from an earlier MiTo fit a later one — say a 2009 car on a 2014 car?
The MiTo was built on a single generation throughout its UK production run (roughly 2008–2018), with a facelift arriving around 2013–2014 that updated the front bumper, lights and grille. Because the bonnet stay rod clips to the bonnet and the engine bay floor rather than to any of those updated front-end panels, it is generally considered generation-wide fitment, but confirm the exact part number with the breaker against your registration to be sure.
Does the trim level — for example Distinctive, Veloce or Cloverleaf — affect which bonnet stay rod I need?
No, the trim level does not affect bonnet stay rod fitment on the MiTo — the bonnet and its associated hardware are shared across trim grades regardless of whether the car is a base model or a Cloverleaf. The stay rod itself has no cosmetic or performance variation between trims, so you can quote any trim-level breaker car and the part should be the same. Just confirm the model year with the breaker to ensure it matches your generation.
Can I get a used MiTo bonnet stay rod from a breaker, and what should I ask for?
Yes, bonnet stay rods are straightforward to source from UK breakers, and because they are simple unpowered components they are very reliable second-hand. When contacting a breaker through Findapart, quote your registration and ask specifically for the 'bonnet stay rod' or 'bonnet prop rod', and mention whether you also need the retaining clip. Breakers will cross-reference your reg to pull the correct part.