Used Alfa Romeo 4C Bonnet Strut

No — the Alfa Romeo 4C does not use a bonnet strut. The 4C's bonnet is a lightweight carbon-fibre or composite panel that is held open by a traditional solid prop rod, not a gas strut. If you're looking for the prop rod itself, search for '4C bonnet stay' or 'bonnet prop rod' rather than a strut.

The 4C was produced from 2013 to 2020 in a single generation with no significant structural bonnet revision, so prop rods from across the production run are generally expected to be the same design. That said, always confirm the part number with the breaker against your exact registration to be sure. A good breaker will be able to cross-reference this quickly.

The 4C's underpinnings and bonnet design did not change significantly across its production life, so there is a reasonable chance the prop rod is identical throughout. However, because small running changes can affect fixings or brackets, you should confirm with the breaker against your registration before purchasing. Never assume fitment is guaranteed on a used part.

The bonnet and its associated hardware are shared between the 4C Coupe and the 4C Spider, as the front-end structure is the same on both body styles. A prop rod from either variant should be the same part, but confirm this with the breaker against your registration to be certain.

No — trim level and engine choice do not affect the bonnet prop rod on the 4C, as the front-end structure is consistent across all variants. The 4C was only ever offered with a turbocharged engine, so there are no naturally aspirated variants to consider. Focus your search on the model year and confirm with the breaker.