Mercedes-Benz X-Class Front Bumper Replacement Parts

The Mercedes-Benz X-Class was produced from 2017 to 2020 and was discontinued without receiving a facelift during its production run, meaning there is only one generation of front bumper to consider. This makes sourcing straightforward compared to models that changed bumper design mid-life. Always confirm the exact part against your registration with the breaker before purchasing.

Because the X-Class ran from 2017 to 2020 as a single generation with no facelift, a front bumper from a 2018 model should be compatible with a 2020 model in principle. There were no known mid-life front-end design changes that would create a fitment boundary between those years. That said, always confirm against your specific registration with the breaker before buying, as minor production variations can occasionally affect fitment.

Engine choice does not affect front bumper fitment on the X-Class — the front-end panels are shared across the engine range within the same generation. Whether your truck runs the four-cylinder 220 d or the V6 350 d, the bumper shell itself is the same part. You can safely ignore the engine code when searching, though always confirm final fitment with the breaker against your registration.

Trim level does not affect the core bumper fitment on the X-Class, as the front bumper shell is shared across Pure, Progressive and Power grades. However, you may find cosmetic differences in bumper finishes, inserts or lower apron styling between trims, so a bumper pulled from a Pure-spec vehicle may look slightly different on a Power-spec truck even if it physically fits. Check the appearance of the donor bumper with the breaker to make sure it matches what you want, and confirm fitment against your registration.

The front bumper on the X-Class is a symmetrical panel that spans the full width of the vehicle, so right-hand-drive versus left-hand-drive status does not normally affect bumper shell fitment. However, fog light positions, parking sensor drilling patterns and number plate recess specifications can differ between markets, so a European-sourced bumper may need modifications. Confirm these details with the breaker before purchasing to avoid unexpected work.

On the X-Class the front bumper is a single one-piece moulding, so breakers will typically supply it as a complete unit rather than as individual corner sections. Some breakers may be able to advise on repair panels or end caps if available, but supply as a whole bumper is the norm in the UK salvage trade. Ask your breaker specifically whether corner sections are available if you want to avoid replacing the entire bumper.