Cheap Mazda CX-30 Alloy Wheels

The Mazda CX-30 launched in 2019 and is a single generation model with no major platform change since then, though there have been running updates and specification changes over the years. For alloy wheel fitment, the key figures to match are the bolt pattern (PCD), offset, and centre bore rather than the model year. Confirm the exact spec of any used wheels against your registration before buying.

Because the CX-30 is a single continuous generation, wheels from earlier and later cars often share the same PCD and centre bore, making cross-year fitment straightforward in many cases. However, Mazda did introduce different wheel sizes and designs at various points, so offset can vary between fitments. Ask the breaker to check the PCD, offset, and centre bore against your registration to be sure, as we cannot guarantee fitment.

Trim level does not affect whether a wheel will physically fit — what matters is the PCD, offset, and centre bore, which are determined by the car's axle and hub rather than the trim. The CX-30 was sold in the UK in trims including SE-L, GT Sport, GT Sport Tech, and Takumi, and these trims came with different factory wheel designs and sizes, so a wheel pulled from a different trim may look or size differently to your original. As long as the PCD, offset, and centre bore match, it should fit, but confirm those figures with the breaker against your registration.

Mazda models within the same era often share a 5x114.3 PCD, which means there is a reasonable chance of compatibility between the CX-5 and CX-30, but the offset and centre bore must also match for a safe fit. Because these are different models with different suspension and hub geometry, you should not assume the offset will be identical. Ask the breaker to verify PCD, offset, and centre bore against your specific registration before purchasing.

TPMS (tyre pressure monitoring system) sensors are fitted to CX-30 wheels from the factory, and whether sensors from a donor car will communicate correctly with your vehicle depends on the sensor type, frequency, and your car's software. This is not something we can confirm as a blanket rule, so raise it directly with the breaker and, if in doubt, have a Mazda dealer or specialist check compatibility against your registration.

The Mazda CX-30 uses a 5x114.3 PCD, which is common across a wide range of Mazda models and makes sourcing used alloys relatively straightforward. Centre bore and offset can vary depending on the specific wheel fitment, so always ask the breaker to confirm these figures match your car's registration rather than relying on general figures alone.