Fiat Panda Bumper Replacement Parts

The third-generation Panda (169 platform) ran from 2003 to 2012, and bumpers from any year within that generation should be broadly compatible with one another, as the front-end panels are shared across the range. However, the Panda received a facelift around 2009 which updated the front bumper styling, so a pre-2009 bumper and a post-2009 bumper are not necessarily the same part. Confirm with the breaker against your registration whether the specific bumper they have is a pre- or post-facelift piece.

These two cars sit either side of the 2009 facelift boundary within the third generation (2003–2012), meaning the bumper design changed around that point. The 2010 car is a post-facelift model and the 2007 is pre-facelift, so the parts may not be a direct swap. Name your registration to the breaker and ask them to confirm whether the specific bumper they have crosses that facelift divide before you buy.

Trim level does not affect bumper fitment on the Panda; Active, Dynamic, and Eleganza all share the same front bumper within a given generation and facelift period. You may find minor cosmetic differences such as the presence or absence of lower grille inserts or fog-light bezels depending on the specification, so check the breaker's photos against your own car. As long as the generation and facelift period match, the trim name on the donor car is not a barrier to fitment.

No — the fourth-generation Panda (312 platform) launched in 2012 and has an entirely different front-end design from the 2003–2012 third-generation car. Parts from the two generations are not interchangeable. Always confirm which generation the breaker's bumper comes from before purchasing.

The fourth-generation Panda (2012 onwards) received a mid-life update around 2020 which refreshed the front styling including the bumper and grille. If your car is a pre-2020 fourth-generation Panda, a bumper from a post-2020 car may look different and could have different fixing points. Confirm with the breaker against your registration whether the part they hold is pre- or post-facelift to avoid buying the wrong piece.

The bumper shell itself is the same part regardless of whether your car has fog lights, but a bumper sourced from a car without fog lights will have blanked-off apertures rather than open housings, and vice versa. This is a cosmetic and finishing difference rather than a structural fitment issue, so you can swap the fog-light bezels or blanks over if needed. Mention to the breaker whether your car has fog lights so they can supply the bumper in the right finishing state.