Alfa Romeo Brera Anti Roll Bar Replacement Parts
Compare prices on a used Alfa Romeo Brera anti roll bar from UK breakers. Free part request, no obligation.
Enter your registration or select your vehicle
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
Buying a used Alfa Romeo Brera anti roll bar: what matters
Fitment on a used anti roll bar varies by vehicle, so a bit of detail goes a long way. Our request form covers what breakers need to know, so every quote you get back is for the correct part:
- State whether it's front or rear
Other used Alfa Romeo Brera parts
- Used Alfa Romeo Brera Tyre
- Used Alfa Romeo Brera Brake Servo
- Used Alfa Romeo Brera Wishbone
- Used Alfa Romeo Brera Front Cross Member
- Used Alfa Romeo Brera Radio
- Used Alfa Romeo Brera Aerial
- Used Alfa Romeo Brera Front Panel
- Used Alfa Romeo Brera Propshaft
- Used Alfa Romeo Brera Curtain Airbag
- Used Alfa Romeo Brera Suspension Leg
- Used Alfa Romeo Brera Brake Caliper
- Used Alfa Romeo Brera Transfer Box
Used anti roll bar for other Alfa Romeo models
Fitment questions
Do Alfa Romeo Brera anti roll bars actually exist, or is it a solid axle setup?
Yes, the Brera uses independent suspension front and rear, so it does have both front and rear anti roll bars as part of that setup. This applies across all Brera variants produced during the model's single generation run from 2005 to 2010, regardless of engine choice.
Will a 2005 or 2006 Brera anti roll bar fit a later 2008 or 2009 car?
The Alfa Romeo Brera ran as a single generation from 2005 to 2010 without a structural platform change, so early and late cars share the same basic suspension architecture. That said, confirm with the breaker against your exact registration before buying, as suspension component specifications can vary within a generation in ways that are not always obvious from the outside.
Does engine size affect which anti roll bar I need for my Brera?
Engine size can influence anti roll bar specification on the Brera, as heavier or more powerful variants such as the 3.2 V6 JTS may have different bar diameters compared to the 2.2 JTS or the 2.4 JTDM diesel. Always give the breaker your registration number so they can match the bar to your specific engine variant rather than assuming all Breras share the same spec.
Does it matter whether I choose a Brera from a lower or higher trim level when sourcing the anti roll bar?
Trim level alone does not affect anti roll bar fitment on the Brera — the bars are part of the suspension structure, not a cosmetic feature, so a bar from a lower-spec car is not automatically different from one on a higher-spec example. What matters more is the engine size fitted to the donor car, so focus on matching that rather than the trim name when speaking to a breaker.
Is the front anti roll bar the same part as the rear on the Brera?
No, front and rear anti roll bars are different parts with different dimensions and mounting points, so you need to be clear with the breaker about which end of the car you are replacing. Make sure you specify front or rear when requesting a quote, and confirm it against your registration to be safe.
Can I use a Brera anti roll bar from a Spider donor car, as they look similar?
The Alfa Romeo Brera coupe and the 939-series Spider share the same platform and running gear, so there is a reasonable basis to expect compatibility between the two models. However, confirm this directly with the breaker against both registrations before purchasing, as subtle differences may exist that are not immediately apparent.