Compare prices on a used Škoda Kamiq dual mass flywheel from UK breakers. Free part request, no obligation.
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
No two dual mass flywheels are quite the same across different vehicles, so getting the specifics right matters when you buy used, second hand or a replacement. Answer a few quick questions below and breakers will only quote if they have the exact matching part in stock:
The Kamiq is a front-wheel-drive only crossover built on the MQB-A0 platform, and whether a dual mass flywheel (DMF) is fitted depends entirely on the engine variant and gearbox combination — it is not fitted to all Kamiq engines. Manual-gearbox petrol and diesel variants are most likely to use a DMF, while DSG (dual-clutch automatic) variants use a different internal damping arrangement built into the transmission itself rather than a separate flywheel. You should confirm whether your specific engine and gearbox combination uses a DMF by checking your engine code (found on your V5C or via a VIN check) with the breaker before ordering.
The Škoda Kamiq was launched in the UK in 2019, with a mid-cycle refresh arriving around 2021–2022, so there is a production boundary worth being aware of. The DMF fitment is driven by the engine code above anything else, so if your pre-facelift and post-facelift cars share the same engine code (for example both running a 1.0 TSI with code DLAA or similar), the part may well interchange — but ancillary and mounting changes can occur across that facelift boundary. Confirm fitment against your specific registration and engine code with the breaker rather than relying on model year alone.
Trim level makes no difference whatsoever to DMF fitment on the Kamiq — SE, SE Drive, Monte Carlo, and Sportline are cosmetic and equipment packages, not mechanical ones. What matters is your engine code, fuel type (petrol or diesel), and whether you have a manual or DSG gearbox, because those are the factors that determine which DMF was fitted at the factory. You may receive a part pulled from a lower or higher trim car than yours and that is perfectly fine mechanically, so don't be put off if the breaker's donor vehicle is a different trim to yours.
Many 1.0 TSI-engined Kamiq models with a manual gearbox do use a dual mass flywheel, but the exact specification depends on the precise engine code stamped on your block — the 1.0 TSI covers several variants across the MQB-A0 platform with codes such as DLAA, CHZD, and others, and not every code shares the same flywheel. Your engine code is the single most useful piece of information you can give a breaker, and you can find it on your V5C or via a VIN decode. Always quote the engine code directly to the breaker so they can match from a confirmed donor vehicle.
The Kamiq, SEAT Arona, VW Polo, and SEAT Ibiza all share the MQB-A0 platform and draw from the same family of engines, so cross-brand DMF compatibility is genuinely possible where the engine codes match. If a Polo or Arona donor car carries the same engine code as your Kamiq, the DMF is likely the same unit — MQB-A0 parts are commonly shared across Volkswagen Group brands at this level. That said, you should always verify the engine code match directly with the breaker and not assume platform similarity alone guarantees fitment.
Give the breaker your full registration number, your engine code (from the V5C or a VIN check — it is usually a three or four letter code stamped on the block), your fuel type, and whether you have a manual gearbox or a DSG automatic. The engine code is more important than the year or trim, because Kamiq variants of the same year can carry different engines with different DMF specifications. Having this information ready will let the breaker confirm quickly whether their donor vehicle is a genuine match for your car.