Used Nissan Vanette Suspension Leg
Need a used Nissan Vanette suspension leg? Request a free quote from UK vehicle dismantlers and compare offers direct.
Enter your registration or select your vehicle
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
A buyer's guide to used Nissan Vanette suspension leg
No two suspension legs are quite the same across different vehicles, so getting the specifics right matters when you buy used, second hand or a replacement. Answer a few quick questions below and breakers will only quote if they have the exact matching part in stock:
- State whether it's front or rear, left or right
Other used Nissan Vanette parts
- Used Nissan Vanette ABS Pump
- Used Nissan Vanette Front Cross Member
- Used Nissan Vanette Brake Discs
- Used Nissan Vanette Brake Light Switch
- Used Nissan Vanette Alloy Wheels
- Used Nissan Vanette Oil Pump
- Used Nissan Vanette Wheel Arch Liner
- Used Nissan Vanette Shock Absorber
- Used Nissan Vanette Ignition Switch
- Used Nissan Vanette Fuel Filter
- Used Nissan Vanette Anti Roll Bar
- Used Nissan Vanette Wiper Motor
Used suspension leg for other Nissan models
Fitment questions
Does the Nissan Vanette actually have a suspension leg, or is it a different type of suspension?
The Nissan Vanette uses a MacPherson strut layout at the front, so yes, it does have front suspension legs (struts). At the rear the setup is a beam or trailing-arm arrangement depending on the generation, so there are no suspension legs at the rear axle. If you need a rear suspension component, let the breaker know exactly which end you are replacing.
Will a suspension leg from an earlier C22 Vanette fit the later C23 model?
The C22 and C23 are distinct generations with different front subframe and strut dimensions, so the suspension legs are not a straightforward swap between them. Name the generation clearly when asking a breaker, and confirm fitment against your registration plate rather than assuming interchangeability across that boundary.
Does the engine size on a Nissan Vanette affect which suspension leg I need?
Running gear on vans is often matched to the vehicle's weight rating rather than solely engine size, so the payload or GVW figure on your vehicle identification plate is the key detail to check. A heavier-rated Vanette variant may carry a different strut specification, so give the breaker your reg and the GVW from the plate to be sure.
Does the trim level on my Nissan Vanette change which suspension leg fits?
Trim level alone does not determine which suspension leg a Vanette needs — the generation, GVW rating, and which side you need (NS or OS) are what matter for fitment. Trim differences on the Vanette are mainly interior and equipment related, so a strut from a base-spec van of the same generation and weight class is worth considering alongside a higher-spec example.
Is the NS (nearside) suspension leg from a Nissan Vanette the same as the OS (offside) one?
No — NS and OS suspension legs are handed and not interchangeable, so always confirm which side you need before approaching a breaker. When requesting a quote, state clearly whether you need the nearside (left, kerb side) or offside (right, driver's side) strut to avoid being sent the wrong unit.
I've seen Vanettes listed with different payload ratings — does that affect the suspension leg I need?
It can do, because van manufacturers sometimes fit heavier-duty suspension components to higher GVW variants to handle the increased load. Check the manufacturer's plate on your vehicle for the exact GVW figure and pass that to the breaker alongside your registration, rather than going only by the model name, as the model name alone will not confirm which specification of strut your van left the factory with.