Cheap Nissan Primastar Suspension Leg
Need a used Nissan Primastar suspension leg? Request a free quote from UK vehicle dismantlers and compare offers direct.
Enter your registration or select your vehicle
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
A buyer's guide to used Nissan Primastar suspension leg
No two suspension legs are quite the same across different vehicles, so getting the specifics right matters when you buy used, second hand or a replacement. Answer a few quick questions below and breakers will only quote if they have the exact matching part in stock:
- State whether it's front or rear, left or right
Other used Nissan Primastar parts
- Used Nissan Primastar Track Rod
- Used Nissan Primastar Shock Absorber
- Used Nissan Primastar Steering Box
- Used Nissan Primastar Wishbone
- Used Nissan Primastar Rear Bumper
- Used Nissan Primastar Brake Pedal
- Used Nissan Primastar Dashboard
- Used Nissan Primastar Clutch Slave Cylinder
- Used Nissan Primastar Subframe
- Used Nissan Primastar Window Regulator
- Used Nissan Primastar Camshaft
- Used Nissan Primastar Anti Roll Bar
Used suspension leg for other Nissan models
Fitment questions
Does the Nissan Primastar actually have a suspension leg?
Yes, the Primastar uses MacPherson strut suspension at the front, so it does have front suspension legs (struts). These are a genuine, standard fitment on this van across its production run, so sourcing a used one from a breaker is straightforward.
Will a suspension leg from an early Primastar fit a later one – does the year matter?
The Nissan Primastar was built on the Renault Trafic / Vauxhall Vivaro platform and ran as a single generation from approximately 2002 to 2016 with a facelift around 2006-2007. Within that generation the front strut design is broadly consistent, but whether a pre-facelift leg crosses directly to a post-facelift van is something you should confirm with the breaker against your exact registration, as subtle geometry or mounting changes can catch buyers out.
Does payload or GVW rating affect which suspension leg I need for my Primastar?
On vans this genuinely matters – higher GVW variants can carry heavier suspension components tuned for greater loads, so a 1200 kg payload van and a lighter-rated van may not share identical struts. Always check the plate inside the driver's door for your van's actual GVW rating and give that figure to the breaker, rather than relying on the model name alone.
Does engine size make a difference – will a 2.0-litre Primastar strut fit a 1.9-litre van?
Engine size can influence the front suspension setup because heavier or more powerful engines sometimes require different spring and damper rates, and the 2.0-litre dCi unit is heavier than the 1.9-litre dTi/dCi. You should tell the breaker both your engine size and your van's GVW rating so they can match the correct strut – do not assume the legs are interchangeable between engine variants without checking.
Does it matter which side I order – NS or OS?
Yes, suspension legs are handed – the nearside (NS, kerb side) and offside (OS, driver's side) are mirror images of each other and are not interchangeable. When contacting a breaker always specify NS or OS clearly, as well as your registration or VIN, to make sure you get the correct unit.
Does the trim level affect which suspension leg fits my Primastar?
Trim level alone does not affect suspension leg fitment on the Primastar – whether your van is a base-spec or higher-grade model, the trim name does not change the strut specification. What does matter is the engine size, GVW rating, and which side you need, so focus on those details when speaking to a breaker rather than the trim level.