Nissan Vanette Wiper Motor Replacement Parts

The Vanette was sold in the UK across two distinct generations — the C22 (roughly the mid-1980s to early 1990s) and the later C23 (early-to-mid 1990s onward) — and the wiper motor design and mounting changed between these generations, so a C22 unit is unlikely to be a straight swap into a C23. If you are sourcing across that generational boundary, confirm with the breaker that the motor matches your exact generation and whether it is front or rear fitment. Never assume a part will fit without verification.

No — engine size has no bearing on wiper motor fitment for the Vanette. What matters is the generation of the van (C22 or C23), whether you need the front or rear motor, and that the connector and mounting pattern match. Tell the breaker your generation and which motor position you need, and ignore engine variants when searching.

Trim level does not affect wiper motor fitment on the Vanette — the motor is determined by the generation and front or rear position, not by whether the vehicle was a base or higher-specification variant. A used motor from a different trim may look slightly different cosmetically (different bracket finish or connector colour), but mechanically it should be the same unit within the same generation. Confirm with the breaker that the generation, motor position, and connector type match your vehicle before purchasing.

The C23 generation of the Vanette was introduced in the early 1990s and covers most mid-1990s UK examples, but if you are unsure of your exact build date or variant, the safest approach is to give the breaker your full registration number so they can confirm the generation before pulling a part. Getting this right matters because the front wiper motor mounting and connector differ between generations. If you have any documentation showing the model code, share that with the breaker too.

No — front and rear wiper motors are not interchangeable on the Vanette; they differ in mounting, shaft configuration, and often electrical connector layout. Always specify to the breaker whether you need the nearside/offside front motor or the rear motor. Fitting the wrong unit will mean it either will not mount correctly or will not operate as intended.

For the wiper motor itself, what matters is the generation (C22 or C23) and whether it is the front or rear unit — body configuration differences within the same generation are unlikely to change the motor specification. However, if you are at all uncertain whether your Vanette shares the same wiper motor as another variant you have found, route this to the breaker and confirm against your registration rather than assuming compatibility.