Used Nissan 350Z Handbrake Cable
Compare prices on a used Nissan 350Z handbrake cable from UK breakers. Free part request, no obligation.
Enter your registration or select your vehicle
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
What to check when buying a used Nissan 350Z handbrake cable
A used handbrake cable that fits one vehicle won't always fit another - even within the same model range. These questions help breakers match stock to your exact vehicle before they quote:
- State whether it's left or right
Other used Nissan 350Z parts
- Used Nissan 350Z Axle
- Used Nissan 350Z Suspension Leg
- Used Nissan 350Z Brake Servo
- Used Nissan 350Z Power Steering Pump
- Used Nissan 350Z Radio
- Used Nissan 350Z Gear Stick
- Used Nissan 350Z Ignition Switch
- Used Nissan 350Z Wishbone
- Used Nissan 350Z Door
- Used Nissan 350Z Sump
- Used Nissan 350Z Door Card
- Used Nissan 350Z Wiper Blades
Used handbrake cable for other Nissan models
Fitment questions
Does the Nissan 350Z actually have a handbrake cable?
No — the Nissan 350Z does not use a traditional cable-operated handbrake. From its launch in 2003 through to the end of production in 2009, all variants of the 350Z were fitted with an electronic parking brake system rather than a mechanical cable. If your parking brake is not working, the fault is likely in the electronic actuator, switch, or wiring rather than a cable.
I've been told I need a handbrake cable for my 350Z — what should I actually be looking for?
Because the 350Z uses an electronic parking brake, there is no handbrake cable to replace in the traditional sense. The components that can fail include the rear caliper actuator motors, the parking brake switch on the centre console, or the associated wiring and control module. A breaker parting out a 350Z can supply these electronic components, so describe the fault to them and they can advise which part you need.
Could a handbrake cable from an earlier Nissan Z-car like the 300ZX fit the 350Z?
No — the 300ZX (Z32) used a conventional mechanical handbrake cable, whereas the 350Z (Z33) moved to an electronic parking brake, so the two systems are completely incompatible and no cable from an earlier Z-car will fit or function on a 350Z. These are entirely different parking brake architectures. If you own a 350Z, you need electronic parking brake components, not a cable.
Does it matter whether my 350Z is a GT, Touring, or GT4 trim when sourcing parking brake parts?
Trim level does not change the fundamental parking brake system — all 350Z variants used the electronic setup regardless of whether the car is a base GT, Touring, or the later GT4. However, it is worth confirming the exact model year with the breaker against your registration, as there were running changes across the 2003–2009 production run that could affect whether a specific actuator or module is a direct match. Your VIN will help the breaker identify the correct electronic components.
My 350Z is a 2006 facelift model — is the parking brake system different from a pre-facelift car?
The 350Z received a notable update around 2006, and while the car retained its electronic parking brake throughout the entire production run, there may be differences in the specific actuator or control module between early (2003–2005) and later (2006–2009) cars. Whether parts interchange across that boundary is something you should confirm with the breaker against your exact registration rather than assume compatibility. A good breaker will cross-reference your VIN to make sure the electronic components supplied match your car's specification.