Second Hand Ford P100 Bonnet

The Ford P100 pickup was produced from 1983 to 1992, based on the Sierra platform throughout its entire run. For bonnet fitment, the key question is whether the donor vehicle is from the same facelift period as yours, as front-end styling changed during production. Always confirm the exact year and any facelift specification with the breaker against your registration before purchasing.

The P100 ran from 1983 to 1992, and there was a facelift during this period that brought changes to the front-end panels including the bonnet, grille and lights. If your vehicle and the donor car sit either side of that facelift boundary, the bonnet may not be a straight swap. Name your registration clearly to the breaker so they can confirm whether the panel from their vehicle matches yours.

No — the engine and trim level do not affect bonnet fitment on the P100, as front-end panels are shared across the range regardless of what is under the bonnet. The P100 was offered in trim levels including L and GL, but these differences do not change the bonnet itself, though there may be minor cosmetic variations such as badging to be aware of. Confirm the specific panel with the breaker against your registration to make sure you are getting the right piece.

The P100 was built on the Sierra platform and shares significant mechanical and structural DNA with the Sierra, so there is some parts crossover between the two models. However, whether the bonnet is a direct interchange depends on the specific body style, year and facelift period of both vehicles, and this is not something to assume. Check this directly with the breaker, giving them both vehicle registrations or VINs, as they will know from experience which Sierra panels cross over to the P100.

Give the breaker your full registration number so they can verify the year and specification of your vehicle and match it against the donor car in their yard. The most important fitment factor is that both vehicles are from the same facelift period, as front-end panels including the bonnet can differ across facelift boundaries. A good breaker will confirm this before the part is dispatched, so always ask the question explicitly rather than assuming a same-era panel will fit.