Compare prices on a used Vauxhall Grandland X body control module from UK breakers. Free part request, no obligation.
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
No two body control modules are quite the same across different vehicles, so getting the specifics right matters when you buy used, second hand or a replacement. Answer a few quick questions below and breakers will only quote if they have the exact matching part in stock:
Yes, the Vauxhall Grandland X is fitted with a Body Control Module (BCM), which manages a wide range of electrical functions including lighting, central locking, and auxiliary systems. It is present across the Grandland X range, which ran from 2017 to 2021 in its original form before the Grandland (without the X) replaced it. All engine and trim variants of the Grandland X include a BCM as standard, so you do not need to worry about whether your particular engine has one.
The Vauxhall Grandland X was a single-generation model sold from 2017 to 2021 with no major structural facelift that is widely documented as altering BCM compatibility, so a 2018 and 2020 unit are broadly from the same generation. However, software calibration, optional equipment packs, and minor running changes can affect whether one BCM works correctly in another car, so you should confirm with the breaker that the donor car shares the same specification as yours, ideally matched against your registration. Programming by a Vauxhall-capable diagnostic technician will almost certainly be required regardless of age match.
The BCM controls vehicle-wide electrical functions rather than trim-specific features in isolation, but the trim level can influence how the BCM is configured, because higher trims like Elite or Ultimate may have features such as heated seats, a larger infotainment system, or a panoramic roof that the BCM is set up to manage. A BCM from a lower trim such as SE fitted into an Elite car may not support all those functions correctly. Confirm with the breaker that the donor vehicle's trim and options match yours as closely as possible, and expect reprogramming to be needed.
The engine type itself is not the primary compatibility factor for a BCM, but the overall vehicle specification, including gearbox type, drivetrain layout, and fitted options, does influence how the BCM is programmed. A BCM from a diesel Grandland X fitted into a petrol one may not control all systems correctly without reprogramming. Confirm the full vehicle specification with the breaker against your registration before purchasing, and factor in the cost of professional programming.
The Grandland (2021 onwards) is a substantially different vehicle from the Grandland X, built on a different platform and sharing a different electrical architecture, so its BCM is very unlikely to be a straight swap. You should specifically source a BCM from a Grandland X (2017–2021) rather than the newer Grandland. Confirm any part with the breaker against your exact registration to be sure.
Yes, in almost all cases a second-hand BCM will need to be programmed or coded to your specific vehicle before it will work correctly, as BCMs are typically matched to the car's VIN and configuration during manufacture or installation. This usually requires a Vauxhall-compatible diagnostic tool, and a specialist or Vauxhall dealer will normally need to carry out the work. Factor this cost into your budget when sourcing the unit from a breaker.