Need a used Škoda Yeti transfer box? Request a free quote from UK vehicle dismantlers and compare offers direct.
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
Used transfer boxs vary between vehicles - and whether you call it used, second hand or a replacement, matching the right one matters. These are the details breakers need to match the right part to your car - our request form asks them so you only hear from suppliers with the correct part:
Yes, but only on four-wheel-drive variants — the Yeti was sold in both front-wheel-drive and 4WD versions, and the transfer box is part of the Haldex-based 4WD system fitted exclusively to the latter. If your Yeti is front-wheel-drive, it will never have had a transfer box. Check your V5 or run a VIN check to confirm which drivetrain your vehicle has before searching for this part.
The Škoda Yeti was produced from 2009 to 2017, with a facelift arriving in 2013 that brought updated engines and some mechanical revisions — so a 2010 unit and a 2014 unit may not be a straightforward swap. Engine code is the most important factor here: if both vehicles share the same engine code and the same 4WD drivetrain, compatibility is much more likely, but whether any ancillary or mounting changes occurred across that 2013 facelift boundary is something you should confirm with the breaker against your specific registration. Never assume fitment purely on year alone.
Trim level — whether Elegance, Active, Ambition or Outdoor — does not affect which transfer box is fitted; what matters is whether the vehicle is 4WD and, above all, what engine code it has. Both an Elegance and an Outdoor with the same engine code and 4WD system should use the same transfer box. Focus on supplying your engine code (found on your V5 or via a VIN check) rather than your trim name when getting quotes from a breaker.
Yes — engine code is the single most important detail for this part, as the transfer box and its associated Haldex unit are calibrated around the specific engine and gearbox combination. A petrol Yeti and a diesel Yeti, even of the same year, may use different specifications, and an automatic will differ from a manual. Always supply your full engine code (stamped on the engine block and listed on your V5) when requesting quotes from a breaker.
Yes, gearbox type matters because the transfer box interfaces directly with the transmission, and the manual and DSG automatic variants use different configurations. Make sure you tell the breaker whether your Yeti has a manual or automatic gearbox, alongside your engine code, to avoid being quoted an incompatible unit. Supplying your registration and engine code together gives the breaker the best chance of matching the correct part.
Whether a replacement transfer box or its associated Haldex controller requires any ECU pairing or coding to your specific vehicle is something you should confirm directly with the breaker or your fitting garage, as this can vary and is not something that can be stated as a general rule. It is worth raising this question before you buy, so you understand any additional work that may be needed after fitment. A good breaker will be able to advise based on the specific unit they are supplying.