Second Hand Nissan NV200 Glove Box
Get quotes for a used or replacement Nissan NV200 glove box. Genuine second hand parts from UK vehicle dismantlers - free request, breakers with stock reply direct.
Enter your registration or select your vehicle
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
Other used Nissan NV200 parts
- Used Nissan NV200 Heater Matrix
- Used Nissan NV200 Steering Wheel Airbag
- Used Nissan NV200 Headrest
- Used Nissan NV200 Seat Belt
- Used Nissan NV200 Quarter Panel
- Used Nissan NV200 Airbag Control Module
- Used Nissan NV200 Steering Box
- Used Nissan NV200 Brake Light Switch
- Used Nissan NV200 Seat
- Used Nissan NV200 Front Panel
- Used Nissan NV200 Rear Bumper
- Used Nissan NV200 Door Card
Used glove box for other Nissan models
Fitment questions
Does a glove box from an older Nissan NV200 fit a newer one?
The NV200 ran as a single generation from 2009 through to around 2021 in the UK market, with a facelift arriving in 2013, so the key question is whether the part crosses that 2013 facelift boundary. Within the pre-facelift (2009–2013) or post-facelift (2013–2021) periods fitment is generally straightforward, but whether a pre-facelift glove box swaps directly into a post-facelift car is something you should confirm with the breaker against your registration, as dashboard trim and fixings can change at a facelift. Give the breaker your reg and they can check the exact spec.
Will the trim level affect which glove box fits my Nissan NV200?
The NV200 was sold in the UK in trim levels including Acenta and Tekna, and while interior quality and finish differ between trims, the glove box itself occupies the same dashboard position across variants. In practice trim level is unlikely to change the fitment, though the colour or finish of the lid may vary, so a glove box from a different trim may look slightly different inside your van. Confirm the exact finish with the breaker if colour-match matters to you.
Does it matter which engine my Nissan NV200 has when buying a used glove box?
No — the engine has no bearing on glove box fitment, as this is a dashboard interior part that is the same regardless of whether your NV200 has the 1.5 dCi diesel or the 1.6 petrol. You can safely disregard engine type when searching, and breakers will not need your engine code for this part. Focus instead on the model year and trim when speaking to the breaker.
I have a 2012 Nissan NV200 — will a glove box from a 2015 model fit?
Your 2012 van is a pre-facelift model, while the 2015 sits in the post-facelift generation that was updated in 2013, meaning the two cars may have differences in dashboard design and fixing points. It is possible the glove box housing or surround differs across that 2013 boundary, so this is a cross-facelift swap that you should confirm with the breaker by providing both registrations. Do not assume it will be a direct swap without that check.
Does the Nissan NV200 actually have a glove box?
Yes — the Nissan NV200 is fitted with a glove box on the passenger side of the dashboard as standard across its production run. It is a genuine used part you can source from a breaker, and it is available for both the pre-facelift (2009–2013) and post-facelift (2013–2021) versions. Make sure to tell the breaker your registration so they can match the correct generation and dashboard spec.
Is there a nearside or offside consideration when buying a used NV200 glove box?
The glove box sits on the nearside (passenger side) of the dashboard in all UK-market right-hand-drive NV200 vans, so there is no offside variant to worry about for this particular part. However, be cautious if a breaker is selling from a left-hand-drive export model, as the dashboard layout will be mirrored and the part will not fit your UK van. Always confirm with the breaker that the donor vehicle is right-hand drive.