Used Mercedes-Benz CLA Handbrake Lever

No — the CLA has never been fitted with a traditional mechanical handbrake lever in any of its variants or generations. All CLA models use an electronic parking brake (EPB), operated by a button or switch on the centre console rather than a pull-up lever. If you're looking for a parking brake component, you most likely need the EPB switch, the EPB actuator/motor on the rear caliper, or a related control module — confirm exactly which part you need with a breaker against your registration.

Because the CLA uses an electronic parking brake throughout its range, the fault is usually in the EPB switch (the button on the centre console), the EPB actuator motor integrated into the rear brake caliper, or the associated wiring and control unit. A breaker will need your registration to identify the correct generation and variant, as the C117 (2013–2019) and C118 (2019–present) generations may use different components. It's worth having the fault diagnosed first with a scan tool so you know which specific part has failed before contacting breakers.

The original C117 CLA ran from 2013 to 2019 with a facelift in 2016, while the C118 generation replaced it from 2019 onwards, so a 2019 CLA could be either generation depending on when in the year it was registered. Switches from the C117 and C118 generations are unlikely to be interchangeable given the significant interior redesign between them, and even within the C117 facelift boundary compatibility is not guaranteed. Always confirm the exact part against your registration with the breaker before purchasing.

Trim level is unlikely to affect the fundamental EPB switch or actuator specification on the CLA, as the electronic parking brake system is shared across the range rather than being trim-specific. You may notice cosmetic differences in the switch surround or centre console finish between trims, but the functional part itself should correspond to generation rather than trim. Confirm with the breaker against your registration to be sure, as individual build variations can always exist on used vehicles.

Engine variant does not typically determine the EPB actuator specification on the CLA — fitment is driven by generation (C117 2013–2019 or C118 2019–present) rather than which engine is fitted. This means a used actuator from a CLA 180 or a CLA 220 of the same generation should in principle be the same part, but you should still confirm this with the breaker against both registrations to rule out any build-specific differences.

UK breakers (vehicle dismantlers) that specialise in Mercedes-Benz are your best option for used EPB switches, rear caliper actuators, or related components from a CLA. When contacting a breaker through Findapart, give them your full registration so they can verify the exact generation and build of your car and match it to the donor vehicle. Because the electronic parking brake is a safety-related system, professional fitting or at minimum a post-fit diagnostic check with a scan tool is strongly advisable.