Used Ford Mondeo Anti Roll Bar

The Mk3 Mondeo ran from 2000 to 2007 and the Mk4 from 2007 to 2014, and these are distinct generations with different suspension geometry, so the anti roll bars are not interchangeable between them. Always quote your registration to the breaker so they can match the correct generation.

Yes, the Ford Mondeo has anti roll bars on both the front and rear axles across all generations, as it uses independent suspension all round — this is a genuine fitment for this model. Both front and rear bars exist as separate parts, so make sure you specify which end you need when getting a quote.

The Mk4 Mondeo ran from 2007 to 2014 with a facelift in 2010, and while the facelift was primarily cosmetic, whether the anti roll bar changed across that boundary is something you should confirm with the breaker against your specific registration rather than assume. Quoting your reg gives the breaker the best chance of pulling the right part.

For standard Zetec and Titanium models, trim level does not affect anti roll bar fitment, and a bar from either should be the same component. However, if your car is an ST or has a sports suspension package, confirm with the breaker against your registration, as there may be differences in bar diameter or mounting that are not obvious from trim name alone.

On the Mondeo, engine size does not typically dictate a different anti roll bar in the way it might affect brakes, so a 1.6 and a 2.0 of the same generation are generally fitted with the same bars. That said, always confirm with the breaker using your registration, as there can be market or specification variations that are not immediately obvious.

Anti roll bars run across the full width of the axle as a single component, so there is no nearside or offside distinction — you simply need to specify front or rear. Make sure you also confirm your Mondeo's generation and body style with the breaker so they can pull the correct bar.