Used Ford Fusion Wishbone

The Ford Fusion was produced for the UK market from 2002 to 2012 as a single generation, based on the Fiesta Mk5/Mk6 platform throughout its run. Because there was no major generation change, many running-gear components carry over across the production span, but there were minor mid-life updates so fitment is not guaranteed across all years. Always give the breaker your exact registration so they can match the part to your specific build date.

The Fusion ran as one continuous generation from 2002 to 2012, so on the face of it early and late cars share the same platform and wishbone design. However, there were incremental updates during that period, and whether a 2005 part crosses cleanly to a 2009 car is something you should confirm with the breaker against your registration rather than assume. They can check the actual part numbers to be sure before you buy.

For the Fusion, the front suspension geometry and wishbone design were not typically varied between the smaller and larger engines in the same way braking hardware sometimes was, since this was a light supermini-based car. That said, running gear can differ with powertrain, so it is worth telling the breaker your exact engine size and registration to rule out any variant differences. This is straightforward information to cross-reference against the part number.

Trim level alone does not affect wishbone fitment on the Ford Fusion – the suspension components are determined by the vehicle's build specification rather than whether it is a Zetec or Ghia. You may find cosmetic differences on a stripped part from a higher-spec car, but the wishbone itself should be the same. Confirm against your registration with the breaker to be certain, but trim is not a factor to worry about here.

Yes, side absolutely matters – nearside (NS, left, kerb side) and offside (OS, right, driver's side) wishbones are handed and are not interchangeable. Always specify NS or OS clearly when requesting a quote from the breaker, and double-check which side needs replacing on your car before ordering. Getting this wrong means the part will not fit.

The Fusion was built on the Fiesta Mk5 platform and there is a reasonable chance that some suspension components are shared, but the Fusion's taller, heavier body may mean the specification differs from the equivalent Fiesta part. This is exactly the kind of cross-model compatibility question you need to put to the breaker directly, quoting both registrations, so they can compare part numbers before committing. Do not assume compatibility without that check.