Compare prices on a used Škoda Yeti sill from UK breakers. Free part request, no obligation.
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
A used sill that fits one vehicle won't always fit another - even within the same model range. These questions help breakers match stock to your exact vehicle before they quote:
The Škoda Yeti was produced in one generation running from 2009 to 2017, with a facelift introduced in 2013 that brought revised exterior styling including changes to the lower body panels, so a pre-facelift sill (2009–2013) and a post-facelift sill (2013–2017) are not guaranteed to be the same pressing. You should name both your registration year and the donor car's year to the breaker so they can confirm whether the panel matches before you commit. Never assume a sill from across that 2013 boundary will fit without that check.
No – sills are structural body panels and are not affected by the drivetrain layout, so a sill from a 2WD Yeti and one from a 4WD Yeti are the same pressing for an equivalent model year. What matters is the model year and whether it is pre- or post-facelift, not whether the donor car had four-wheel drive. Confirm the year range with the breaker against your registration to be safe.
Trim level does not affect sill fitment on the Yeti – the panel itself is the same pressing regardless of whether the car was an S, SE, Elegance, or Outdoor. The one thing to be aware of is that some trim levels came with body-coloured lower trims or cladding attached to the sill area, so a sill from a different trim may look slightly different cosmetically even if it fits perfectly. Make sure you match the model year and facelift status rather than worrying about trim designation.
The Yeti Outdoor was a styling variant rather than a structurally different body, but it typically featured additional plastic cladding around the lower body including the sill area, which can make a bare sill panel look different from a standard car. The underlying metal sill panel for the same model year is likely the same, but whether the cladding and any attached trim pieces interchange exactly is something you should confirm with the breaker against your specific registration rather than assume.
A 2011 Yeti is a pre-facelift car and a 2015 is post-facelift, which means there is a known styling revision at the 2013 facelift that may have involved changes to exterior body panels including the sill area. You should not assume these will interchange directly, and you need to ask the breaker to check the specific part numbers or physically compare the panels against your registration before buying. Routing this across the facelift boundary to the breaker for confirmation is strongly advised.
No – engine choice has no bearing whatsoever on sill fitment, as the sill is a body structural panel entirely unrelated to what is under the bonnet. Whether your Yeti is a 1.2 TSI, 1.4 TSI, 2.0 TDI, or any other variant, the sill panel is determined by the body and model year, not the engine. Focus on matching the year and facelift status when sourcing from a breaker.