Findapart

Used Škoda Yeti Gear Stick

Need a used Škoda Yeti gear stick? Request a free quote from UK vehicle dismantlers and compare offers direct.

Enter your registration or select your vehicle

Find the right part faster and get quotes direct from UK breakers - free, and no obligation.

GB

A buyer's guide to used Škoda Yeti gear stick

No two gear sticks are quite the same across different vehicles, so getting the specifics right matters when you buy used, second hand or a replacement. Answer a few quick questions below and breakers will only quote if they have the exact matching part in stock:

Other used Škoda Yeti parts

Used gear stick for other Škoda models

Fitment questions

Does a gear stick from an earlier Škoda Yeti fit a later one?

The Škoda Yeti ran from 2009 to 2017 in a single generation, with a facelift arriving in 2013 that brought some interior and trim updates. The gear stick assembly may differ across that 2013 facelift boundary, so a pre-2013 unit may not be a straightforward swap into a post-2013 car even if the gearbox type matches. Your engine code (found on your V5 or a VIN check) and gearbox type are the most important details to give the breaker, and you should confirm whether the specific part crosses that facelift boundary with them before buying.

Does the engine type affect which gear stick fits my Škoda Yeti?

Yes — the Yeti was available with several petrol and diesel engines paired to either a manual or DSG automatic gearbox, and the gear stick assembly differs significantly between these. A manual gear stick is a completely different unit to a DSG selector, so you must confirm your gearbox type as well as your engine code when requesting a quote. Supplying your engine code (stamped on the engine or listed on your V5) gives breakers the single most reliable reference point for finding the right part.

Will a gear stick from a Škoda Yeti Elegance fit a Yeti S or Yeti SE?

Trim level — whether S, SE, Elegance, or Outdoor — does not affect which gear stick assembly was fitted, as this is determined by the gearbox type and engine code rather than the specification level. A used gear stick from any trim should physically correspond to the same part if the gearbox and engine match, though cosmetic differences such as the gear knob material or finish may vary between trims. Check the appearance of the donor part if the finish matters to you, but mechanically the trim name is not a fitment concern.

Does it matter whether my Škoda Yeti is 2WD or 4WD when buying a gear stick?

The drivetrain layout (2WD or 4WD) does not itself dictate which gear stick you need, but it can be indirectly relevant because certain engine and gearbox combinations were more commonly paired with 4WD. The gearbox type — manual or DSG — is what really governs fitment, so focus on confirming that alongside your engine code. Give both pieces of information to the breaker so they can match the correct assembly from their stock.

Is there anything about a used Škoda Yeti gear stick that needs coding or pairing to the car?

A conventional manual gear stick is a purely mechanical assembly and does not require any electronic coding to the vehicle. However, DSG selector units on automatic Yetis may involve electronic components that could need attention during fitting, and whether any pairing to the car's systems is required is something you should confirm directly with the breaker or a VAG-specialist technician against your registration. Do not assume a DSG selector is a straight plug-and-play swap without checking first.

What details should I have ready when asking for a quote on a used Škoda Yeti gear stick?

The most important details are your engine code, your gearbox type (manual or DSG), and the year of your car — these three pieces of information allow breakers to identify the correct part far more reliably than the trim name or colour. Your engine code appears on your V5 logbook or can be retrieved via a VIN check, and it is the single most useful thing you can supply. If you also know whether your car is pre- or post-2013 facelift, mention that too, as it may be relevant to ancillary components within the assembly.