Get quotes for a used or replacement Škoda Yeti bonnet strut. Genuine second hand parts from UK vehicle dismantlers - free request, breakers with stock reply direct.
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
Yes, the Škoda Yeti uses gas-filled bonnet struts to hold the bonnet open — there is no prop rod on this model, so if yours has failed the bonnet won't stay up on its own. There are typically two struts, one on each side (nearside and offside), and both should ideally be replaced at the same time as they wear at a similar rate. You'll find used struts readily available from breakers who have dismantled Yetis.
The Škoda Yeti was produced as a single generation from 2009 to 2017, but it received a significant facelift in 2013 that updated the front end including the bonnet, lights, grille, and bumper. Because the bonnet itself changed at the facelift, the strut geometry and fitment points may also differ between pre-facelift (2009–2013) and post-facelift (2013–2017) cars. When searching for a used strut, knowing which side of that 2013 boundary your car sits on is the key question to get right.
A 2012 Yeti is pre-facelift and a 2015 Yeti is post-facelift, and because the front-end sheet metal was revised in 2013 it is not safe to assume the struts are interchangeable across that boundary. You should confirm directly with the breaker, quoting your registration, so they can check the mounting points match before you commit to buying. Never assume a pre-facelift part will drop straight into a post-facelift car without that verification.
Trim level does not affect bonnet strut fitment on the Yeti — the S, SE, Elegance, and any other trim variants all share the same bonnet and strut setup within the same facelift period. You may find cosmetic differences around the front end between trims (such as different grille finishes or fog light surrounds), but the strut itself is unaffected by those changes. Focus on whether the donor car is pre- or post-facelift rather than worrying about trim.
No — the engine type and drivetrain (front-wheel drive or 4WD) do not affect bonnet strut fitment, as the bonnet and its supporting struts are the same across all powertrain variants within a facelift period. A strut pulled from a 2.0 TDI 4x4 Yeti will be the same as one from a 1.2 TSI front-wheel-drive car, provided both are from the same facelift era. Just confirm the pre- or post-2013 facelift status with the breaker using your registration.
If one strut has failed it is generally recommended to replace both at the same time, as they wear together and a mismatched pair can cause the bonnet to sit unevenly or the working strut to fail soon after. When buying used from a breaker, ask whether they can supply a matched pair from the same donor vehicle, which gives you the best chance of balanced performance. Always confirm fitment against your registration before purchasing.