Need a used Škoda Roomster rear bumper? Request a free quote from UK vehicle dismantlers and compare offers direct.
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
No two rear bumpers are quite the same across different vehicles, so getting the specifics right matters when you buy used, second hand or a replacement. Answer a few quick questions below and breakers will only quote if they have the exact matching part in stock:
The Škoda Roomster ran from 2006 to 2015 as a single generation, with a facelift arriving in 2010 that brought styling changes including to the rear bumper. Parts from within the pre-facelift period (2006–2010) should swap among themselves, and facelift parts (2010–2015) should swap among themselves, but crossing that 2010 boundary is where fitment becomes uncertain — confirm with the breaker against your registration before buying.
This swap crosses the 2010 facelift boundary, and the rear bumper design changed at that point, so a direct fit is not guaranteed. Confirm with the breaker using both registrations, as they can check the exact pressing and mounting points against your car.
Trim level does not change the underlying bumper shell or its mounting points on the Roomster, so a bumper from a Classic will fit a Comfort or Scout of the same facelift phase. Bear in mind that Scout models had body-coloured lower cladding styling differences, so the bumper you source may look slightly different to your original; confirm the colour code and finish with the breaker so there are no surprises.
The Roomster was sold in a single distinctive MPV-style body throughout its production life, so there are no saloon, estate, or hatch alternatives to confuse things. This makes body style a non-issue for this model — your main concern is simply whether the part is pre- or post-2010 facelift.
The Roomster shared PQ24 platform underpinnings with other VAG models, but rear bumpers are body-specific panels shaped to each individual car's styling, so an Altea bumper will not physically fit a Roomster. Stick to Roomster-specific parts and confirm the exact year with the breaker against your registration.
Give the breaker your full registration number so they can verify whether your car is pre- or post-2010 facelift, as this is the key fitment boundary for the Roomster rear bumper. Also confirm the paint colour code (usually found on a sticker in the spare wheel well or door shuts) so the breaker can match or advise on the finish, and ask them to check the part against your specific reg rather than year alone in case of any mid-run changes.