Get quotes for a used or replacement Škoda Karoq rear bumper. Genuine second hand parts from UK vehicle dismantlers - free request, breakers with stock reply direct.
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
A used rear bumper that fits one vehicle won't always fit another - even within the same model range. These questions help breakers match stock to your exact vehicle before they quote:
The Škoda Karoq has been sold in one generation, launched in 2017, with a facelift arriving for the 2022 model year that brought subtle changes to the rear styling and bumper pressing. A pre-facelift bumper (2017–2021) and a post-facelift bumper (2022 onwards) are unlikely to be a straight swap, so confirm with the breaker which side of that 2022 boundary the donor car sits before buying.
Both the 2018 and 2021 Karoq sit within the pre-facelift generation (2017–2021), so the bumper should be from the same pressing run. That said, confirm the part number against your registration with the breaker, as minor mid-run changes can catch buyers out.
Trim level does not affect rear bumper fitment on the Karoq — the underlying panel is the same across SE, SE L, Sportline, and other grades. You may find cosmetic differences such as diffuser inserts, sensor hole configurations, or trim colour, so let the breaker know your exact spec so they can match the finish as closely as possible.
The Karoq, Ateca, and Tiguan share the MQB platform, but each has its own unique body panels and the rear bumper is not shared between them. Whether there are any pressing similarities between specific Karoq variants and close platform siblings is something to confirm with the breaker against your registration rather than assume.
No — engine and gearbox make no difference to rear bumper fitment on the Karoq. Focus instead on the model year to establish whether you need a pre-facelift (2017–2021) or post-facelift (2022 onwards) bumper, and confirm sensor and trim hole requirements with the breaker.
Parking sensor hole configuration is determined by your car's factory spec rather than trim level or model year alone, and a bumper from a car without sensors may need drilling, while one from a different sensor layout may not match exactly. Give the breaker your registration and let them check the donor car's original spec so you get a bumper with the correct hole pattern, rather than relying on year or trim as a guide.