Need a used Škoda Enyaq radiator fan? Request a free quote from UK vehicle dismantlers and compare offers direct.
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
No two radiator fans are quite the same across different vehicles, so getting the specifics right matters when you buy used, second hand or a replacement. Answer a few quick questions below and breakers will only quote if they have the exact matching part in stock:
The Enyaq is a fully electric vehicle (BEV), so it has no internal combustion engine and no engine-driven or engine-cooling radiator fan of the kind found on petrol or diesel cars. Electric motors and their power electronics do use liquid cooling circuits, and those circuits may include an electric coolant pump or a small electric fan for the heat exchanger or HVAC condenser, but there is no traditional radiator fan as the term is understood for ICE vehicles. If you need cooling-system components for an Enyaq, you are likely looking for an HVAC condenser fan, a battery thermal management pump, or a heat exchanger assembly — check with the breaker describing exactly what you can see on the car.
The Enyaq (launched in the UK in 2021, based on the MEB platform) uses electric auxiliary fans — typically a front-end cooling module fan that serves the air-conditioning condenser and the power-electronics heat exchanger, rather than engine cooling. The correct search terms are likely 'condenser fan', 'front cooling module', or 'radiator pack fan' rather than 'radiator fan'. Because the Enyaq has had running production changes since 2021, including the iV 60, iV 80, iV 80x and RS variants with differing power outputs, confirm with the breaker that the assembly from a donor vehicle matches your specific variant and registration.
The Enyaq has been in production from 2021 onwards on the MEB platform, and Škoda introduced a facelift in 2024 that brought styling and feature changes; whether the front-end cooling module or condenser fan carried over unchanged across that facelift boundary is not something that can be stated with certainty. You should give the breaker both vehicles' full registrations or VIN numbers so they can cross-reference part numbers and confirm compatibility before purchase. Do not assume year-to-year interchangeability even within the pre-facelift range, as ancillary mounting and wiring configurations can change mid-production.
Trim level on its own does not determine cooling fan fitment, but the RS variant uses a higher-output dual-motor all-wheel-drive setup which may use a different or uprated front cooling module compared to the single-motor iV 60 or iV 80. The relevant detail is the drivetrain specification and power output of the donor vehicle versus your own, not the badge or interior trim. Tell the breaker your exact variant (e.g. iV 80, iV 80x, RS) along with the registration so they can match the correct assembly.
The Enyaq, VW ID.4, and SEAT el-Born (Cupra Born) do share Volkswagen's MEB architecture and some components are common across the platform, which is why MEB-platform parts sometimes interchange. However, whether a specific fan or condenser module is a direct bolt-on fit depends on whether the part numbers match, and physical packaging differences between brands can mean that electrically identical components are mounted differently. A breaker with MEB platform experience will be best placed to cross-reference part numbers against your registration and advise whether a donor car from a sister model is acceptable.