Need a used Škoda Enyaq engine wiring loom? Request a free quote from UK vehicle dismantlers and compare offers direct.
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
No two engine wiring looms are quite the same across different vehicles, so getting the specifics right matters when you buy used, second hand or a replacement. Answer a few quick questions below and breakers will only quote if they have the exact matching part in stock:
The Škoda Enyaq is a fully electric vehicle with no combustion engine, so it does not have an engine wiring loom in the traditional sense. What the Enyaq does have is a high-voltage battery system, power electronics, and an electric motor with associated wiring harnesses, but these are not the same as a petrol or diesel engine wiring loom. If you have been quoted for or are searching for an engine wiring loom on an Enyaq, it is likely you or the listing is using the wrong terminology for the part you actually need.
Depending on your fault or repair, you may be looking for the high-voltage battery wiring harness, the electric motor wiring harness, the front or rear inverter wiring loom, or the low-voltage 12V vehicle wiring harness. The Enyaq was introduced in 2021 on the MEB electric platform and received a facelift in 2024, so the specific harness you need will depend on your model year and drivetrain — single-motor rear-wheel drive or dual-motor four-wheel drive (iV versions). Describe your fault and your exact registration to a breaker, who can identify the correct harness from their dismantled stock.
Yes, it matters significantly — the 60 and 80 are single-motor rear-wheel-drive variants, while the 80x and RS iV are dual-motor four-wheel-drive variants, and they use different motor and inverter hardware with different associated wiring harnesses. The iV 80 Sport, SE, and Sportline trim names do not affect which harness is fitted; what matters is the drivetrain configuration and model year. Always give the breaker your full registration so they can confirm the correct harness against the actual vehicle specification.
The Enyaq received a notable facelift in 2024 which brought updates to its powertrain electronics and exterior, meaning there is a real risk that wiring harnesses from pre-facelift 2021–2023 cars will not be a straightforward swap onto a 2024 model. Even within the pre-facelift generation you should confirm compatibility against your specific build date and drivetrain type, as running changes can occur mid-production. Route this question directly to the breaker with your registration and the donor vehicle's registration to confirm before purchasing.
Trim level does not determine which motor or inverter harness is fitted — that is dictated by the drivetrain variant (rear-wheel drive or four-wheel drive) and the model year. An Enyaq RS iV will have a dual-motor harness because of its four-wheel-drive powertrain, but that is a drivetrain difference, not a trim difference in isolation. Focus on drivetrain type and build year rather than the badge when describing your needs to a breaker.
Give the breaker your full registration number so they can look up the exact build specification, drivetrain configuration, and model year — this is far more reliable than going on the trim name or badge alone. It is also worth noting which specific harness has failed (motor side, battery side, 12V system) so the breaker can identify the right part from the donor vehicle. Whether ECU or battery management coding is required when fitting a used harness is something you must confirm with the breaker and your technician, as this is not something that can be guaranteed in advance.