Cheap Mercedes-Benz MB100 Rear Tailgate

The MB100 was a single-generation light van sold in the UK through the late 1980s and into the 1990s, and tailgate fitment is tied to that single platform run rather than to any major generational break. Within that production span, wheelbase (short or long) and whether your van has a tailgate or barn doors are the critical variables — a tailgate from a barn-door van simply will not fit. Confirm the exact production year and body configuration with the breaker against your registration before ordering.

Because the MB100 ran as a single platform without a major structural redesign, tailgates from earlier and later vehicles in the range are generally based on the same bodyshell. However, Mercedes did introduce minor pressing or trim changes during a production run of this age, so fitment across different production years cannot be guaranteed without checking. Always confirm the donor vehicle's year against your own registration with the breaker, who can compare part numbers before the part leaves the yard.

Yes — wheelbase is one of the most important factors for van rear panels, and the MB100 was offered in short-wheelbase and long-wheelbase variants with different rear-end dimensions. A tailgate from a short-wheelbase MB100 will not correctly fit a long-wheelbase version and vice versa. Tell the breaker your wheelbase when requesting a quote so they can match the correct donor vehicle.

No — barn doors and a tailgate are fundamentally different assemblies with different hinges, latches, and aperture hardware, so the two are not interchangeable even from the same vehicle. You need to source a tailgate from another MB100 that was also fitted with a tailgate from the factory. Be specific with the breaker about your door configuration when requesting a quote.

Trim level does not determine which tailgate shell fits your MB100 — the structural panel is the same across specification levels on a given wheelbase and body configuration. You may find cosmetic differences between parts pulled from different-spec vans, such as badging, finisher strips, or glass options, so check those details with the breaker if a clean match matters to you. The key questions remain wheelbase, roof height if applicable, and tailgate versus barn-door configuration.

Roof height directly affects the rear aperture and tailgate dimensions on panel vans, so a standard-roof tailgate will not fit a high-roof MB100 and vice versa. When contacting a breaker, confirm both your wheelbase and your roof height so they can source from a matching donor vehicle. Never assume a tailgate fits based on year alone — body configuration is the deciding factor for this part.