Get quotes for a used or replacement Mazda Bongo sunroof. Genuine second hand parts from UK vehicle dismantlers - free request, breakers with stock reply direct.
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
No two sunroofs are quite the same across different vehicles, so getting the specifics right matters when you buy used, second hand or a replacement. Answer a few quick questions below and breakers will only quote if they have the exact matching part in stock:
Yes — the Mazda Bongo (sold in the UK as an imported Japanese-market van, based on the Ford Freda / Mazda Bongo platform from the mid-1990s through to around 2006) was available with a factory fitted pop-up or sliding sunroof panel as an option on certain variants. Because these were Japanese domestic market imports rather than UK-spec vehicles, sunroof fitment varied by the original Japanese trim and options, so it's worth confirming with the breaker that the donor vehicle actually has a sunroof before ordering.
The Mazda Bongo ran on a single generation platform throughout its UK import lifespan (broadly mid-1990s to mid-2000s), and the body pressing for the roof area remained largely consistent across this production run. In practice most sunroof units from this era are considered interchangeable, but because these are grey imports with varying Japanese trim configurations, you should confirm the exact dimensions and mechanism type with the breaker against your registration before purchasing.
No — engine choice has no bearing whatsoever on sunroof fitment, as the roof panel and mechanism are entirely independent of drivetrain. You can safely ignore engine type when searching for a donor sunroof and focus instead on confirming the body style and roof configuration match.
The Bongo Friendee is a higher-roofed leisure variant of the same platform, and its roof profile differs significantly from the standard Bongo van, meaning a sunroof from a standard Bongo is very unlikely to fit a Friendee and vice versa. Always confirm with the breaker which body style the donor vehicle is — standard Bongo or Friendee — and verify it matches your own before agreeing a price.
Trim level does not affect the physical fitment of the sunroof aperture or mechanism — the roof pressing is the same regardless of specification grade. Bear in mind that the glass, trim surround, or mechanism style may look slightly different between donor and recipient vehicles depending on original Japanese factory options, so confirm with the breaker that the unit matches your existing setup cosmetically as well.
Give the breaker your vehicle's chassis number if possible, and confirm whether your Bongo is the standard van body or the taller Friendee body, as these are not interchangeable. Also let them know whether your existing sunroof is a pop-up tilt type or a sliding panel type, as both were fitted across the range and the mechanisms differ — this will help the breaker match the correct unit from their donor vehicle.