Second Hand Mazda 6 Power Steering Pump

It depends on the generation. The first-generation Mazda 6 (GG/GY, 2002–2007) used a conventional hydraulic power steering system and does have a physical power steering pump. The second-generation (GH, 2008–2012) transitioned to electric power steering (EPS) on most variants, and the third-generation (GJ, 2013 onwards) is fully electric power steering throughout, meaning neither the GH nor GJ has a hydraulic pump to replace. If you have a 2008 or newer Mazda 6 and your steering assistance has failed, you are most likely looking for an electric power steering rack or EPS control module rather than a pump.

Both years fall within the first-generation Mazda 6 (GG/GY, 2002–2007), so fitment is generally more likely than crossing a generation boundary, but engine size is important to check — the pumps used on the 2.0-litre and 2.3-litre petrol engines are not necessarily identical. Confirm your engine size with the breaker and give them your registration so they can cross-reference the part against your exact build. Never assume direct swap without that check.

Trim level — whether S, TS, TS2, or Sport — does not affect which power steering pump was fitted to the first-generation Mazda 6; the pump is determined by the engine and generation, not the interior or equipment grade. You may find cosmetic differences on the car you are buying from (different interior condition, extra switches), but the pump itself should correspond to the same engine variant regardless of badge. Always confirm engine size matches when speaking to the breaker.

This is a generation boundary question: the first-generation Mazda 6 (GG/GY) ran to 2007, while the second-generation (GH) began in 2008 and largely moved to electric power steering. A 2008 GH Mazda 6 is therefore unlikely to have a hydraulic pump at all, making a cross-generation swap essentially impossible in most cases. Confirm what steering system your specific 2007 car has and speak to a breaker with your registration before pursuing any cross-generation part.

Yes, engine size is a key fitment factor for the hydraulic power steering pump on the 2002–2007 Mazda 6. The 2.0-litre and 2.3-litre petrol engines, as well as the diesel variants, may use different pump specifications, so you should always tell the breaker your exact engine size alongside your registration number. Do not rely on generation alone to establish compatibility.

The third-generation Mazda 6 (GJ, 2013 onwards) uses electric power steering and does not have a hydraulic pump, so there is no pump to replace on this vehicle. Heavy or failed steering assistance on a GJ Mazda 6 points instead to a fault with the EPS motor, steering rack, or associated control electronics. A breaker can help you source the correct electric steering rack or EPS components once you confirm the fault with a diagnostic check.