Used Ford P100 Timing Chain
Need a used Ford P100 timing chain? Request a free quote from UK vehicle dismantlers and compare offers direct.
Enter your registration or select your vehicle
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
Choosing the right used Ford P100 timing chain
Used timing chains vary between vehicles - and whether you call it used, second hand or a replacement, matching the right one matters. These are the details breakers need to match the right part to your car - our request form asks them so you only hear from suppliers with the correct part:
- State whether it's petrol or diesel
- State the engine code if known
Other used Ford P100 parts
Used timing chain for other Ford models
Fitment questions
Does the Ford P100 have a timing chain or a timing belt?
The Ford P100, produced from 1983 to 1992, used engines carried over from the Ford Sierra and Transit family — specifically the 2.0 OHC Pinto petrol engine and the 2.5 diesel engine, both of which use a timing chain rather than a belt. So if you need to replace the timing chain on a P100, this is a genuine part for the vehicle. Confirm the exact engine code from your V5 or a VIN check before ordering, as the chain and associated components can vary between engine variants.
Will a timing chain from an early P100 (mid-1980s) fit a later P100 (early 1990s)?
The Ford P100 ran as a single generation from 1983 to 1992, receiving a facelift in 1987 that updated the bodywork but did not fundamentally change the engine lineup — so engine codes are your primary guide to compatibility, not the model year alone. If the engine code on a later P100 matches that on an earlier one, the timing chain is very likely the same part, but any ancillary changes to tensioners or guides through that production run are worth confirming with the breaker against your registration. Never assume fitment purely on year without cross-referencing the engine code.
Does the trim level affect which timing chain I need for my Ford P100?
No — the Ford P100's trim level has no bearing on timing chain fitment whatsoever. The chain is determined entirely by the engine fitted, so whether your truck is a base or higher-specification model, what matters is the engine code stamped on the block, not what badges or equipment it carries. Provide the engine code to your breaker and they can match the part correctly.
Is the timing chain the same on the P100 2.0 petrol and the 2.5 diesel?
No, the 2.0 OHC Pinto petrol engine and the 2.5 diesel are different engines with different timing chain setups, so the parts are not interchangeable between them. Always specify the fuel type and engine code clearly when requesting a quote from a breaker. If you are unsure of your engine code, your V5 logbook or a VIN check will confirm it.
Can I use a timing chain from a Ford Sierra or Transit on my P100?
Because the P100 shared engines with the Ford Sierra (2.0 Pinto) and the Transit range (2.5 diesel), there is a reasonable chance of parts crossover, and breakers familiar with those vehicles may well stock compatible chains. However, engine specification variants and any production changes across those model families mean you should confirm compatibility with the breaker using your exact engine code rather than assuming a straight swap. A good breaker will cross-reference the part number against both vehicles before supplying.