Used Fiat Qubo Alloy Wheels

The Fiat Qubo was sold in the UK from 2008 to 2021 as a single generation with no major structural redesign during that period. The bolt pattern (PCD) is 4x98 throughout the production run, which it shares with many other Fiat models of the same era. This means alloys from any year of Qubo are broadly compatible with any other year, provided the offset and centre bore also match. Always confirm the exact offset and centre bore against your registration with the breaker before buying.

The Fiat Qubo uses a 4x98 PCD, which is the same bolt pattern found across a wide range of Fiat models including the Punto and certain Doblo variants of the same era. Offset and centre bore also need to match for a safe fit, and these can vary between models even within the same manufacturer family. Alloys that share the correct PCD, offset, and centre bore will generally interchange, so this is a realistic avenue to explore. Give the breaker your Qubo's registration so they can verify the offset and centre bore figures before committing.

Trim level does not affect alloy wheel fitment on the Fiat Qubo — what matters is the PCD, offset, and centre bore, not whether the car is a base Dynamic, Active, or higher specification. Different trims may have been fitted with different alloy styles or sizes from the factory, so a set from a higher-spec car may look different to what your car originally wore. The wheels themselves will physically fit across trims as long as the key measurements match. Bear in mind you may end up with a different spoke design or finish than the original, which is purely cosmetic.

Because the Fiat Qubo ran as a single generation from 2008 to 2021 without a major platform change, a wheel from a 2010 car and one from a 2018 car are expected to share the same 4x98 PCD. Provided the offset and centre bore are also matching, fitment across those years is generally straightforward. Confirm the specific offset figure with the breaker against both registrations to be certain, as minor variations can exist.

If your Fiat Qubo is fitted with a tyre pressure monitoring system (TPMS), any second-hand alloys you buy may or may not come with compatible sensors, and sensor compatibility is not straightforward to confirm at a distance. Confirm with the breaker whether sensors are included and whether they are likely to be compatible with your specific car before purchasing. A tyre fitter can advise on programming or replacing sensors once you have the wheels in hand.

The Fiat Qubo has a centre bore of 58.1 mm, which needs to match or be accommodated by the alloy you are fitting — if the wheel's centre bore is larger, a spigot ring can be used, but if it is smaller the wheel simply will not seat correctly. This measurement is just as important as the PCD and offset for safe fitment. When sourcing second-hand alloys, check this figure with the breaker alongside the bolt pattern and offset to avoid buying wheels that won't fit.