Cheap Mercedes-Benz B-Class Handbrake Cable

The W245 B-Class (2005–2011) uses a traditional mechanical handbrake with a physical cable, so a used handbrake cable is a genuine part you can source from a breaker. The later W246 B-Class (2011–2018) moved to an electric parking brake (EPB) on most variants, which is motor-actuated and does not use a conventional handbrake cable in the same way. If you own a W246, you are likely looking for an EPB actuator or motor rather than a cable — confirm with the breaker exactly which parking brake system your car has by quoting your registration.

Both a 2007 and a 2009 B-Class fall within the W245 generation (2005–2011), which used a conventional handbrake cable throughout its run, so there is a reasonable chance of compatibility. However, engine size can influence brake and running gear specifications, so confirm with the breaker that the donor car matches your engine variant as well as the generation. Never assume fitment without checking against your registration.

On the W245 B-Class, the B180 and B200 are relatively close in terms of brake and running gear, but the larger-engined B200 may carry slightly different rear brake specifications that could affect cable routing or length. It is worth telling the breaker both the exact engine code and the year of your car so they can check against the donor vehicle. Do not assume the cable from a B180 will be a guaranteed fit on a B200 without that confirmation.

Trim level alone — whether SE, Sport, or Elegance on the W245 — does not determine the handbrake cable fitment, as the cable is dictated by the generation, engine size, and rear brake setup rather than the trim designation. You should not need to match trim when sourcing a used cable, though it is always worth confirming the engine variant and model year with the breaker. Cosmetic or interior differences between trims are irrelevant to this part.

A 2012 B-Class is a W246, which is the generation that introduced an electric parking brake on most models, meaning there is typically no conventional handbrake cable to replace. What you most likely need is an electric parking brake actuator or a related electronic component rather than a cable. Confirm your exact parking brake setup with a breaker quoting your registration, as they can verify which system is fitted to your specific car.

Yes — rear handbrake cables on the W245 B-Class run individually to each rear wheel, so nearside (NS, left) and offside (OS, right) cables are not interchangeable. When contacting a breaker, specify clearly which side you need, as well as your engine size and year, to make sure you get the correct cable. Fitting the wrong side could mean the cable is the wrong length or does not route correctly to the brake mechanism.