Mazda RX-8 Handbrake Cable Replacement Parts
Need a used Mazda RX-8 handbrake cable? Request a free quote from UK vehicle dismantlers and compare offers direct.
Enter your registration or select your vehicle
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
A buyer's guide to used Mazda RX-8 handbrake cable
No two handbrake cables are quite the same across different vehicles, so getting the specifics right matters when you buy used, second hand or a replacement. Answer a few quick questions below and breakers will only quote if they have the exact matching part in stock:
- State whether it's left or right
Other used Mazda RX-8 parts
- Used Mazda RX-8 Brake Pedal
- Used Mazda RX-8 Brake
- Used Mazda RX-8 Wheel Trims
- Used Mazda RX-8 Tyre
- Used Mazda RX-8 Air Filter
- Used Mazda RX-8 Steering Wheel Airbag
- Used Mazda RX-8 Differential
- Used Mazda RX-8 Roof Panel
- Used Mazda RX-8 Bulkhead
- Used Mazda RX-8 Washer Pump
- Used Mazda RX-8 Door Handle
- Used Mazda RX-8 Rear View Mirror
Used handbrake cable for other Mazda models
Fitment questions
Does the Mazda RX-8 actually have a handbrake cable?
No — the RX-8 uses an electrically operated parking brake on the rear calipers rather than a traditional mechanical handbrake cable, so there is no handbrake cable to source for this vehicle. If your parking brake is not holding or the mechanism is failing, the part you are most likely looking for is a rear caliper with an integrated electric parking brake motor, or the actuator/motor unit itself. A breaker specialising in RX-8s will be able to point you toward the correct rear brake components for your car.
My RX-8 handbrake feels weak — could it be a stretched cable I need to replace?
Because the RX-8 does not use a cable-operated handbrake, a weak or ineffective parking brake is not caused by a worn cable. The most common causes on this model are a faulty rear caliper electric motor, a corroded or seized caliper piston, or a software or sensor fault with the electric parking brake system. A specialist breaker or garage familiar with the RX-8 can help you identify whether you need a replacement rear caliper assembly or another component.
Is there any variant of the RX-8 — 192, 231, or R3 — that has a traditional handbrake cable?
No variant of the RX-8 — whether the 192 PS or 231 PS engine, or trim levels including the R3 — was fitted with a conventional mechanical handbrake cable; all use the electric parking brake system. Trim level makes no difference here, as this is a drivetrain and braking architecture choice that applies across the entire model range. If you have seen a cable listed somewhere for an RX-8, it is worth checking with the breaker whether it relates to a different component entirely.
Will rear brake parts from an early RX-8 (2003–2008) fit a facelift car (2008–2012)?
The RX-8 received a facelift in 2008, and while the basic electric rear caliper design carried over, there can be differences in the caliper specification between pre-facelift and post-facelift cars. You should confirm against your registration with the breaker before purchasing any rear brake components across that 2008 boundary, as the part numbers may differ. A good breaker will be able to cross-reference the exact caliper required for your specific car.
What should I search for instead of a handbrake cable on my RX-8?
The parts most commonly needed when the RX-8 parking brake fails are the rear brake caliper assembly (which contains the electric motor), the electric parking brake motor or actuator on its own if that unit is available separately, or occasionally the electronic control unit associated with the system. When contacting a breaker, give them your registration and describe the fault — for example whether the brake is stuck on, will not engage, or is showing a warning light — so they can supply the most appropriate used part.