Get quotes for a used or replacement Mazda CX-30 propshaft. Genuine second hand parts from UK vehicle dismantlers - free request, breakers with stock reply direct.
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
No two propshafts are quite the same across different vehicles, so getting the specifics right matters when you buy used, second hand or a replacement. Answer a few quick questions below and breakers will only quote if they have the exact matching part in stock:
Only some CX-30s have a propshaft — specifically those fitted with Mazda's i-Activ AWD four-wheel-drive system, which uses a propshaft to transfer drive to the rear axle. Front-wheel-drive CX-30 variants have no propshaft at all, so if your car is front-wheel drive you will not find this part because it was never fitted. Check your V5C or the sticker inside the driver's door jamb to confirm whether your car is AWD before searching further.
The CX-30 has been produced in a single generation since its 2019 UK launch with no full model change through to the current range, so the basic architecture is shared across those years. However, propshaft dimensions can vary depending on engine size and AWD system calibration, so a 2020 unit is not automatically a guaranteed swap onto a 2022 car. Confirm the exact engine code and AWD specification with the breaker against your registration before purchasing.
Yes, engine choice can influence propshaft specification because higher-torque engines may use a differently rated driveline — the CX-30 AWD range has been offered with 2.0-litre petrol, 2.5-litre petrol, and 2.0-litre mild-hybrid engines in the UK. You should always tell the breaker your exact engine size and code, not just that you have a CX-30 AWD, to ensure you get the correctly matched part. Never assume a propshaft from a lower-powered variant will be an identical fit on a higher-powered one.
Trim level alone does not determine propshaft fitment — what matters is whether your specific car has AWD and which engine it carries, both of which can be found across multiple trim grades. An SE-L AWD and a Takumi AWD with the same engine should share the same propshaft specification, while cosmetic differences between trims are completely irrelevant to this part. Confirm AWD and engine details with the breaker rather than relying on trim name alone.
No — a front-wheel-drive CX-30 has no propshaft, so that component cannot be the cause of your symptoms. Drivetrain noise or vibration on an FWD CX-30 is more likely to point to driveshafts (also called CV shafts), wheel bearings, or gearbox mounts. A breaker or mechanic can help you identify the correct part once you have diagnosed the fault more precisely.
Used AWD CX-30 propshafts are available through Findapart, where UK vehicle dismantlers (breakers) can quote you directly. When requesting quotes, provide your registration number, engine size, and confirmation that your car is AWD so the breaker can match the part accurately. Because the CX-30 is a relatively modern car, supply of used parts can be limited, so acting promptly on any available stock is advisable.