Second Hand BMW i3 Bumper
Get quotes for a used or replacement BMW i3 bumper. Genuine second hand parts from UK vehicle dismantlers - free request, breakers with stock reply direct.
Enter your registration or select your vehicle
Find the right part faster and get quotes direct from UK breakers - free, and no obligation.
Choosing the right used BMW i3 bumper
Used bumpers vary between vehicles - and whether you call it used, second hand or a replacement, matching the right one matters. These are the details breakers need to match the right part to your car - our request form asks them so you only hear from suppliers with the correct part:
- State whether it's a front or rear bumper
Other used BMW i3 parts
Used bumper for other BMW models
Fitment questions
What years does the BMW i3 bumper fit – are there different generations?
The BMW i3 was produced from 2013 to 2022 and had a notable facelift in 2017, which brought revised front and rear bumpers along with updated light clusters. Parts from the pre-facelift (2013–2017) and post-facelift (2017–2022) periods are the key fitment groups to be aware of. Always confirm the exact boundary year with the breaker against your registration, as cars registered around 2017 may fall either side depending on build date.
Will a 2015 BMW i3 bumper fit a 2019 BMW i3?
A 2015 i3 is pre-facelift and a 2019 i3 is post-facelift, so these sit either side of the 2017 facelift boundary where bumpers and surrounding panels were redesigned. It is unlikely a direct swap would work, but whether a specific bumper can be made to fit across that boundary is something you must confirm with the breaker against your exact registration. Do not assume interchange without that check.
Does the BMW i3 bumper differ between the standard i3 and the i3s trim?
The i3s, introduced with the 2017 facelift, has visually different front and rear bumpers with a more aggressive, wider appearance compared to the standard i3 of the same period. Fitment for the bumper is therefore trim-relevant in this case – an i3s bumper is not the same panel as a standard i3 bumper even when the cars are the same age. When sourcing from a breaker, make sure to specify whether your car is the standard i3 or the i3s.
Does it matter whether my BMW i3 has the Range Extender (REx) engine when sourcing a bumper?
No – the engine or powertrain variant, including the Range Extender, does not affect bumper fitment on the i3. Front and rear bumpers are shared across i3 and i3 REx versions within the same facelift period. You only need to match the generation and whether your car is a standard i3 or i3s.
Does the colour of the lower bumper trim on my BMW i3 mean I need a specific part?
The i3 was offered with different exterior colour packs affecting the bumper's lower body-colour or contrasting sections, so the panel you source may look different cosmetically even if it is the correct fitment for your car. Structurally the bumper will fit regardless of colour or pack, but you may need to paint or accept a colour mismatch. Confirm the finish with the breaker so you know what to expect when the part arrives.
How do I tell a breaker which BMW i3 bumper I need?
Give the breaker your full registration number, specify whether you need the front or rear bumper, and confirm if your car is the standard i3 or the i3s – this is the most important distinction alongside the facelift year of 2017. The breaker can then check their stock against your exact build date rather than just the model year. This is especially important if your car was registered close to the 2017 facelift changeover.