Second Hand Volkswagen Transporter Scuttle Panel

The Transporter has run through several well-established generations: the T4 ran from 1990 to 2003, the T5 from 2003 to 2015 (with a facelift in 2009), and the T6 from 2015 onwards (with a T6.1 refresh in 2019). Knowing your generation is the starting point for finding a matching scuttle panel, as the panels are completely different between generations. Check your registration or VIN plate to confirm which generation you have before approaching a breaker.

Both years fall within the T5 generation (2003–2015), but this question spans the 2009 facelift, which is the key boundary to be aware of. The scuttle panel pressing may or may not have changed at that point, and this is something you should confirm with the breaker against your registration rather than assume. A good breaker will cross-reference your reg to the exact pressing before supplying the part.

For a scuttle panel, which sits at the base of the windscreen between the bonnet and the bulkhead, wheelbase and roof height do not affect fitment — this is a front-of-vehicle panel that is common across short and long wheelbase variants and low and high roof versions within the same generation. What matters is generation and any pressing changes within that generation. Confirm the exact part against your reg with the breaker to be safe.

No — barn doors versus tailgate is a rear-end difference and has no bearing on the scuttle panel, which is at the front of the vehicle. You can disregard that detail entirely when sourcing this part. Focus instead on confirming your generation and any mid-generation changes with the breaker.

Trim level does not affect scuttle panel fitment on the Transporter — the panel is structural and the same pressing is used across Startline, Trendline, Comfortline, and Highline variants within the same generation. You may find cosmetic differences such as paint finish or whether grommets are pre-cut, but these do not affect whether the panel physically fits. Your breaker can advise on any minor finishing differences when you give them your registration.

No — the T5 (2003–2015) and T6 (2015 onwards) are different generations built on revised bodyshells, and the scuttle panels are not interchangeable. Always source a scuttle panel from the same generation as your vehicle. Confirm the exact year and variant of your T6 with the breaker, particularly if your vehicle is a post-2019 T6.1, as there may be further pressing differences to account for.