Used Volkswagen Crafter Front Grille

The Crafter has run in two main generations: the first-generation Crafter (sometimes called the 2E/2F platform, shared with the Mercedes Sprinter) ran from 2006 to 2016, and the second-generation Crafter (VW's own MAN-derived platform) launched in 2017 and continues to the present day. Front grilles are not interchangeable between these two generations as the entire front-end design changed. Always quote your registration to the breaker so they can confirm the exact part.

Both a 2013 and a 2016 Crafter fall within the first-generation (2006–2016) range, so they share the same platform and front-end structure. However, there was a facelift within the first generation around 2011 that updated the front-end styling including the grille, so a pre-facelift grille may not match a post-facelift vehicle even though both are first-gen. Confirm the specific part number with your breaker against both registrations before buying.

Yes, both a 2019 and a 2021 Crafter are second-generation (2017-onwards) models sharing the same front-end architecture, and wheelbase or roof height make no difference to grille fitment. There was a mid-cycle update to the second-generation Crafter around 2022 that refreshed the front end, so for vehicles either side of that boundary you should check with the breaker against your registration to be sure. For two vehicles both clearly within the pre-2022 build period, fitment is generally consistent.

Trim level does not determine which front grille fits a Crafter – the panel itself is shared across Startline, Trendline, and Highline variants within the same generation and facelift period. What can vary is the finish or chrome detailing, so a grille pulled from a higher-spec Highline may look slightly different cosmetically to one from a Startline van even though it physically fits. Your breaker should be able to advise on finish differences when you supply your registration.

No, wheelbase makes no difference to front grille fitment on the Crafter – the front-end panels are shared across short, medium, and long-wheelbase variants within the same generation and facelift period. The same applies to roof height; a high-roof Crafter uses the same grille as a low-roof version. Generation and facelift period are the key details to give your breaker.

No – the first-generation Crafter (2006–2016) and the second-generation Crafter (2017-onwards) have completely different front-end designs and the grilles are not interchangeable. The second generation was an entirely new VW platform with a redesigned cab, so none of the first-gen front panels carry over. You will need a grille sourced from a 2017-onwards second-generation Crafter to match your vehicle.